General Electric Cooktop Elements and Burners

General Electric Appliance Parts
Shop By Part Type

Popular General Electric Cooktop Elements and Burners

Your Price
$16.71
  In Stock
Burner Cap - Black - Medium - 9500 BTU
★★★★★
★★★★★
(15)
PartSelect Number PS954202
Manufacturer Part Number WB29K10023
This burner cap is for your gas range, and acts as a cover for the burner head. It is black in color and just over 3 inches in diameter. If your old burner cap is damaged or missing, this is the part that will replace it. This is an OEM part sourced directly from the manufacturer and is sold individually.
Installation Instructions
John from Simi Valley, CA
Missing burner head and all 4 caps on cook top.
All I needed to do was replace the missing burner head and caps. Cook top is now back in service. Thanks for getting me the parts in a very timely manor! Read more...
Your Price
$21.02
  In Stock
Burner Cap - 15K
★★★★★
★★★★★
(16)
PartSelect Number PS954107
Manufacturer Part Number WB28K10222
This is a replacement burner cap for your gas range or cooktop. The burner cap is found on the burner head, and prevents debris from getting into the head when it is not in use. The cap is black in color and is sold individually. It is a little more than 4 inches in diameter. To replace the burner cap, simply remove the damaged cap, and replace it with the new one. No tools are required for this repair. This is an OEM part from the manufacturer.
Installation Instructions
Alejandro from Newark, NJ
The Burners and Burner Caps were missing
Very simple repair. I bought the Range without the Burners and Burner Caps. So all I had to do was to purchase the Burners and the Burner Caps and drop them in. Wish everything in life would be that simple. Read more...
Your Price
$13.78
  In Stock
Burner Cap
★★★★★
★★★★★
(15)
PartSelect Number PS954203
Manufacturer Part Number WB29K10024
This is a burner cap for your gas range. The cap acts as a cover for the burner head. If your old burner cap is damaged or missing, this is the part that will replace it. The cap is black in color and about 3 and a half inches in diameter. This is a quality OEM part sourced directly from the manufacturer. This cap is sold individually.
Installation Instructions
John from Simi Valley, CA
Missing burner head and all 4 caps on cook top.
All I needed to do was replace the missing burner head and caps. Cook top is now back in service. Thanks for getting me the parts in a very timely manor! Read more...
Your Price
$8.67
  In Stock
Burner Cap - 5000 BTU - Black
PartSelect Number PS954201
Manufacturer Part Number WB29K10022
This is a burner cap for your gas range. The cap is black in color and about 3 inches in diameter. The cap acts as a cover for the burner head. If your old burner cap is damaged or missing, this is the part that will replace it. This is a quality OEM part sourced directly from the manufacturer. This cap is sold individually.
Installation Instructions
John from Simi Valley, CA
Missing burner head and all 4 caps on cook top.
All I needed to do was replace the missing burner head and caps. Cook top is now back in service. Thanks for getting me the parts in a very timely manor! Read more...
Your Price
$112.16
  In Stock
Dual Radiant Element - 9 Inch
★★★★★
★★★★★
(26)
PartSelect Number PS2321567
Manufacturer Part Number WB30T10133
The dual radiant element for your range or cooktop provides the heat that you cook with. It is found under the main cooktop. If your element will not heat, you will need to replace it with this part. This radiant element is 9 inches in diameter and is the larger of the two element sizes on your range. Be sure to disconnect your range from the power source before completing this repair. This radiant element is sold individually.
Fixes these symptoms
Installation Instructions
Andrea from ORLANDO, FL
9" Radiant Element did not heat up.
I started by Unscrewing the range top. 2 small screws. I took off the old piece by unclipping the piece . Then I color coded each wire so that I would know exactly where I would place the wires for the new part. 30 min maximum time spent changing the part. Please don't forget to unplug the range before you start. Read more...
Your Price
$26.91
  In Stock
Surface Burner Terminal Block Kit
★★★★★
★★★★★
(17)
PartSelect Number PS242972
Manufacturer Part Number WB2X8228
Also known as receptacle.
Fixes these symptoms
Installation Instructions
Robert from Mt. Vernon, IN
The Bake-o-lite (Hard Plastic) block that holds the burners female connection in place had chipped away over time and wouldn't allow the male part of the burner to connect up correctly.
After unplugging the range I took the rear sheet metal panel at the top off with a nut driver to expose the wiring connections. The next step was to remove the single screw holding the old part in place. (under the drip pan) Once free I snipped the old part from the wires and then taped the new female ends to the old wires with black electrical tape. From rear I carfully pulled the old wires through the back until I could reach the new wiring connections. Unplugged old, plugged in new and replaced the rear metal cover. Then I put the screw that holds the new block bracket in place, replaced drip pan, and burner. The final step was to plug the range back in and check to see if the burner worked. It did and I was done. Approx. 5 minutes Read more...
Your Price
$48.80
  In Stock
Radiant Element - 8 Inch
★★★★★
★★★★★
(24)
PartSelect Number PS2321566
Manufacturer Part Number WB30T10132
This radiant stovetop element, or burner, is a genuine replacement part, and is 8 inches in diameter. The radiant element heats your cookware as you prepare food on the stovetop. To complete this repair, you will need a screwdriver to remove the screws holding the cooktop in place. Lift the cooktop up, and remove the screw and clip holding the old burner in place. Replace with the new element.
Fixes these symptoms
Installation Instructions
Vilas from HANOVER TWP, PA
Back burner was not working.
Took top of stove off, disconnected the heating element, re-installed the new element and now my stove works fine. Read more...
Your Price
$57.92
  In Stock
Surface Element - 6 Inch - 240V
★★★★★
★★★★★
(7)
PartSelect Number PS243867
Manufacturer Part Number WB30M1
If you notice that your surface element will not heat properly, you may need to replace it. This surface element is 6 inches in diameter and 240V. It is a Y-frame surface burner element with five turns and a metallic center medallion. When completing this repair, if you notice any signs of corrosion or overheating on the terminal, you may want to consider replacing the terminal block as well as the surface element. Many of our customers have rated this repair as easy. To complete this repair, simply tilt the old element up and remove it, and then replace it with your new one.
Fixes these symptoms
Installation Instructions
John from San Ramon, CA
I needed new surface elements & burner bowls
This was about the simplest fix I've ever done. Just pulled off the old surface elements & burner bowls, wiped down the range top, and put in the new parts. Perfect fit. No problems at all. $$ well spent. ParsSelect shipped quickly, and they arrived well packaged. A+ experience all around. Thanks PartSelect. JA, San Ramon, CA Read more...
Your Price
$50.01
  In Stock
Surface Element - 8 Inch - 2350W
★★★★★
★★★★★
(17)
PartSelect Number PS243868
Manufacturer Part Number WB30M2
The surface element, also known as the coil surface element, transfers heat to the area on top of range. The element is 8 inches in diameter. If your surface element does not heat, over heats, or heats inconsistently, replacing this part can be the solution to your issue. To determine whether the element is defective, use a multimeter to test it. Before installing the new element, make sure the drip bowl is properly aligned with the notch of the pan. Insert the new element into the reciprocal at a 40 degree angle. Refer to the instructions provided by the manufacturer for more guidance.
Fixes these symptoms
  • Element will not heat
  • Little to no heat when broiling
  • See more...
Installation Instructions
John from San Ramon, CA
I needed new surface elements & burner bowls
This was about the simplest fix I've ever done. Just pulled off the old surface elements & burner bowls, wiped down the range top, and put in the new parts. Perfect fit. No problems at all. $$ well spent. ParsSelect shipped quickly, and they arrived well packaged. A+ experience all around. Thanks PartSelect. JA, San Ramon, CA Read more...
Your Price
$23.38
  In Stock
Small Burner - 5K
★★★★★
★★★★★
(8)
PartSelect Number PS3486550
Manufacturer Part Number WB16K10070
Sold individually.
Fixes these symptoms
Installation Instructions
Alejandro from Newark, NJ
The Burners and Burner Caps were missing
Very simple repair. I bought the Range without the Burners and Burner Caps. So all I had to do was to purchase the Burners and the Burner Caps and drop them in. Wish everything in life would be that simple. Read more...

Related Parts