Briggs and Stratton Small Engine Parts

Briggs and Stratton Appliance Parts

Popular Briggs and Stratton Small Engine Parts

Your Price
$6.78
   In Stock
Briggs and Stratton Small Engine Filter- A/C Cartridge
★★★★★
★★★★★
4 Reviews
PartSelect Number PS8987387
Manufacturer Part Number 491588S
This is a replacement air filter/AC cartridge for your small engine. The air filter prevents dirt and debris from entering the engine. Over time, the air filter can become clogged or damaged, and this can lead to reduced performance. This air filter is approximately 4 inches wide and approximately 5 inches long. To replace the air filter, locate the air filter cover on the side of the engine, unscrew it, and remove the old filter. Be sure to clear out any dirt, clippings, or other debris that has found its way into the air filter assembly before you insert the new filter. Reattach the air filter cover, and secure it with the screws. This product is sold individually.
Fixes these symptoms
Installation Instructions
Barry from FRANKFORT, KY
replaced gasket that go's between the air cleaner housing and carb. cleaned housing and reinstalled with new air filter
Also replaced fuel tank , the built in fuel shut off started leaking , had to replace the tank. Ordered a new one Briggs & Stratton original equipment fit perfect . This is a 25 year old Briggs & Stratton lawn mower 3.5 HP, Runs perfect, starts by the 2nd crank every time. First time I ever had to spend money on it since I bought it new in 1991 Read more...
Your Price
$4.42
   In Stock
Briggs and Stratton Small Engine Plug-Spark
★★★★★
★★★★★
1 Review
PartSelect Number PS9140427
Manufacturer Part Number 796112S
This part is the replacement spark plug for your engine. It measures approximately 2.5 inches by 1 inch. The spark plug creates the spark that ignites fuel in your engine during the combustion process. Over time, spark plugs can become worn and can go bad, which will prevent the engine from firing. You can test your spark plug for continuity with a multimeter, and inspect it for corrosion if you suspect the spark plug has gone bad. This is an OEM part sourced directly from the manufacturer and it is sold individually.
Fixes these symptoms
Installation Instructions
David from KNOXVILLE, TN
Replace carburetor
Loosened engine cover and moved out of the way
Removed air intake and filter
Loosened and disconnected gas line to carburetor
Unscrewed carburetor and disconnected from throttle arm
Reversed process using new carburetor, O-ring and gasket
Read more...
Your Price
$17.26
   In Stock
Briggs and Stratton Small Engine Carburetor Overhaul Kit
★★★★★
★★★★★
4 Reviews
PartSelect Number PS8984098
Manufacturer Part Number 498260
This is a replacement carburetor overhaul kit for your small engine. The carburetor is essential to the overall performance of your engine, and the carb can get clogged up over time for a variety of reasons. When your carb becomes clogged, it is often a good idea to take it apart and replace the various parts inside by purchasing a carburetor kit. This is a 15-piece set and contains everything that you will need to do a total overhaul of your carburetor. You may want to purchase some carb cleaner as well, to ensure that the new pieces in the carb kit fit and adhere properly.
Fixes these symptoms
Installation Instructions
Jonathan from LIBERTY TWP, OH
Smelled Gas Leaks
Inspected/removed fuel lines and found signs of leak. Removed and inspected carburetor and found that seals and gaskets were toast. Replaced said seals with ones from the kit that fit and replaced fuel lines.

Would be nice to have a fuel line kit with the big fuel line (tank to carb) and the little one (carb to engine) together with all the necessary clamps.
Read more...
Your Price
$5.14
   In Stock
Briggs and Stratton Small Engine Grommet
★★★★★
★★★★★
2 Reviews
PartSelect Number PS9064851
Manufacturer Part Number 692187
This grommet is an OEM part that is a 45-degree elbow for the crankcase breather tube of your mower engine. That is why it is also known as a 45-degree breather tube. The part is made of rubber and is black in color. You must purchase this part individually. Your grommet may require replacing if you notice dark smoke coming out of the exhaust. This is a telltale sign that your grommet has become cracked and damaged. Other symptoms are a reduction in the mower performance, or a backfiring engine. According to our customers, this is an easy repair. It requires no tools. Simply attach the grommet to the breather tube from the crankcase to the carburetor.
Your Price
$5.14
   In Stock
Briggs and Stratton Small Engine Grommet
★★★★★
★★★★★
1 Review
PartSelect Number PS9294797
Manufacturer Part Number 692189
This OEM grommet, also called a 90-degree breather tube, is sold individually. Black in color and made of rubber, this is a 90-degree elbow for the crankcase breather tube of your mower engine. If you notice a reduction in the mower engine performance, and engine backfires, this part is likely to be in need of replacing. It can develop cracks due to fatigue, and our troubleshooting tip is to inspect this part if dark smoke is coming out of the exhaust, it is a telltale sign. This is an easy repair to make, and does not require any tools. The new grommet attaches on the breather tube fromt he crankcase to the carburetor.
Your Price
$26.43
   On Order
Briggs and Stratton Small Engine Gear-Governor
★★★★★
★★★★★
1 Review
PartSelect Number PS9151758
Manufacturer Part Number 793338
Installation Instructions
rodney from MUSCATINE, IA
governor not working
Had to pull the engine off the rider mower. Drained the oil took shield off the flywheel. Set it upside down on a 5 gal bucket. Took a 7/16 hand wrench to remove governor lever from bottom of engine. Left it in its location. Pulled 10 1/2 " bolts. Split engine case. Found the old governor had broke into pieces. Had to use a magnet to remove all the pieces. Removed the small clip and removed gear. Lubed shaft slid new on put new clip on. Lined governor weights with center piece tapped it in place very lightly. Cleaned gasket flanges pulled the shaft seal. Used the old seal as a seal driver. When putting the cover back on make sure the seal dont roll out. Take a mini screwdriver and tuck it in around shaft. Put bolts back in and tighten like instructions Read more...
Your Price
$7.58
   In Stock
Briggs and Stratton Small Engine Seal--Oil (PTO Side)
★★★★★
★★★★★
2 Reviews
PartSelect Number PS9151828
Manufacturer Part Number 795387
This OEM Seal-Oil (PTO Side), also called the Oil Seal, is a Black, Nitrile Rubber, 2/14 O.D., individually sold part which is installed using a Seal Puller. Customers rate the installation difficulty as Medium. This part provides a seal around the crank shaft and engine block. When installing onto the engine block around the crank shaft, use something that makes contact around the entire seal, like a large socket or pipe, and tap into place evenly, ensuring that the housing is clean and dry. If the part is broken, likely due to fatigue, there will be leaking oil, and this part should be replaced using the model number on the original part to confirm it is the right fit for your model.
Installation Instructions
rodney from MUSCATINE, IA
governor not working
Had to pull the engine off the rider mower. Drained the oil took shield off the flywheel. Set it upside down on a 5 gal bucket. Took a 7/16 hand wrench to remove governor lever from bottom of engine. Left it in its location. Pulled 10 1/2 " bolts. Split engine case. Found the old governor had broke into pieces. Had to use a magnet to remove all the pieces. Removed the small clip and removed gear. Lubed shaft slid new on put new clip on. Lined governor weights with center piece tapped it in place very lightly. Cleaned gasket flanges pulled the shaft seal. Used the old seal as a seal driver. When putting the cover back on make sure the seal dont roll out. Take a mini screwdriver and tuck it in around shaft. Put bolts back in and tighten like instructions Read more...
Your Price
$34.55
   In Stock
Briggs and Stratton Small Engine Diaphragm-Carburetor
★★★★★
★★★★★
3 Reviews
PartSelect Number PS8937201
Manufacturer Part Number 270026
This is a carburetor diaphragm, which is an OEM part that pumps fuel from the tank to the engine. It is roughly 1x2 inches and black in color. Sold individually, this part can fail due to fatigue and wear, and if it is broken you may notice your engine is running rough or not starting. If your engine exhibits these signs of being starved of fuel, your diaphragm is damaged and needs to be replaced. Our customers found this repair to be of medium difficulty. It requires a wrench, screwdriver, and pliers to complete. You will be able to locate your diaphragm inside the carburetor itself to swap it out with your new one.
Installation Instructions
FRANK from EASTANOLLEE, GA
Screw can out of the carburator throttle baffel and stuck in the exhaust valve
No compression. Removed the cylinder head. freed the screw, checked the valve to see if it still sealed. Turned the head over with the valves in it, install a spark plug, fill the head dome with gas and see if any leeks out over a 2 hr period. If not you are good to go. Reinstalled every thing with new gaskets and a new carburetor screw. Set the valves to spec. Complete the rebuild and there you have it. Rebuild the carburetor while you have it apart. This motor runs great !!! Read more...
Your Price
$6.33
   Special Order
Briggs and Stratton Small Engine Gasket--Rocker Cover
PartSelect Number PS8941245
Manufacturer Part Number 272475S
This OEM Gasket Rocker Cover, which can also be called the Valve Cover Gasket, is used to provide a seal between the valve cover and engine. This is a gray-colored part, measuring 5 1/2 x 4 Inch, and it is sold individually. It can be attached using a wrench or socket. Note: this part also requires a Torque Wrench. When installing, tighten and torque in alternating patterns, following the manufacturer specficiations. You will know when it needs to be replaced when there is oil leaking around the valver cover gasket, which is a sign the part is broken, likely due to simple wear and tear or constant dryness. To make sure you are purchasing the right part, check your model number. Customers rated this repair as easy.
Installation Instructions
Gerald from MAULDIN, SC
Replace fuel diaphragm, fuel pickup tube and air cleaner
This 5hp B&G was manufactured in 1985! Had been garage kept and always dependable. After 10 years of non use the carb wasn't getting gas. Removed air cleaner box, muffler and crankcase breather to easily remove carb, replace parts and reassemble. Read more...
Your Price
$4.99
   In Stock
Briggs and Stratton Small Engine Air Cleaner Gasket
★★★★★
★★★★★
3 Reviews
PartSelect Number PS9138757
Manufacturer Part Number 795629
The Air Cleaner Gasket is used to provide a seal between the air cleaner base, and carburetor. It's a gray, composite material part, which is rated as "Easy" to install and will require a screw driver, pliers, socket set, and nut driver. It attaches between the base of the air cleaner assembly and carburetor. If broken, damaged or worn down it will allow dirt to enter the carburetor, causing performance issues. If this happens, replace it. Refer to your make, model and diagrams to check if this is the right part.

Briggs and Stratton Small Engine Appliance Types

Popular Briggs and Stratton Small Engine Models

Below are the most popular Briggs and Stratton Small Engine models we have. Enter your model number in the search box to find your model.