Models
>
RMS679
RMS679 Caloric Range - Overview
Models starting with RMS679
Click on the best match to narrow your results.
Keep searches simple, eg. "belt" or "pump".
Square Chrome Drip Pan
PartSelect #: PS11757427
Manufacturer #: WPY0060872
The drip pan is found under the burner. This square chrome stovetop drip pan is intended for use with gas ranges. It has a 4-inch diameter center hole and 7 3/4 inch sides. Drip pans should be cleaned...
$27.48
In Stock
Gas Burner Grate
PartSelect #: PS11740765
Manufacturer #: WP314647B
This gas burner grate is used for some gas ranges and cooktops. This is a black burner grate with each side measuring almost eight inches. This part may become rusted or burnt over time if not properl...
No Longer Available
Suface Burner Ignition Switch
PartSelect #: PS11742283
Manufacturer #: WP4157180
When the gas burner valve knob is depressed and turned, this part creates a spark that lights the gas and starts the burner.
$65.30
In Stock
Oven Seal - Top or Bottom
PartSelect #: PS1757448
Manufacturer #: Y07623602
This piece of oven door seal has a metal hook on each end. This seal is compatible with the top and the bottom of the oven door window.
No Longer Available
Top Burner Knob
PartSelect #: PS2197378
Manufacturer #: Y07589201
Sold individually. This knob accepts a D-shaped shaft.
No Longer Available
Bake or Broil Spark Igniter
PartSelect #: PS1757316
Manufacturer #: Y07491300
Also known as spark electrode. This part helps your burner ignite and produce flame.
No Longer Available
Side Oven Door Seal
PartSelect #: PS11757501
Manufacturer #: WPY07623603
This single oven door side seal is fourteen inches long. It is made of black rubber and it has a metal hook in each end.
No Longer Available
Spark Module
PartSelect #: PS2033659
Manufacturer #: 31829401
The color of the original part or the part you receive may be different from the pictured part. This is still the correct part.
No Longer Available
Bake or Broil Spark Igniter
PartSelect #: PS11757497
Manufacturer #: WPY07491300
This part is found in your gas range, also known as spark electrode. This part helps your burner ignite and produce flame. This will need to be replaced if it is no longer providing spark to start the...
$70.05
In Stock
Common Symptoms of models starting with RMS679
[Viewing 1 of 1]
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
electric ignite gas stove kept clicking the ignitor unless unplugged from electrical outlet
I removed the 2 screws that held the housing on at the back of the stove. Then I removed the 2 screws that held the module to the back of the stove. Since I am not an experienced electrical person (I am a female nurse in the operating room), I unplugged 1 wire at a time from the old module and plugged it into the new module. I repeated th
... Read more
is step with each wire to make sure I didn't put the wrong wire on a wrong spot until I had all the wires to the new module. Then reattached the screws, plugged in the oven and presto, it works just fine! Was amazed at how easy it was. A 50 dollar part instead of a new 1500 dollar stove. How easy is that?
Read less
Parts Used:
-
Diana from Jacksonville, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
10 of 11 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Ignitor did not spark when turning the know
Had to remove the 4 range knobs, and the oven knob and then the facie. Two screws under the end caps and two on each side from the back on each end. Design defect: one of these screws which attaches through the frame to the facie also attaches the support which holds up the range top. Take that one off last. Remove the two wires that atta
... Read more
ch to the oven light switch. After detaching the power supply to the defective ignition unit, it just pulls right off. Push the new switch on over the knob shaft and reassemble.
Read less
Parts Used:
-
Richard from Lansing, MI
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
9 of 11 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The Oven Would Not Light
Removed the defective igniter, removing one screw and disconnected wire, replaced new ignighter in reverse fashion. And WELLA! The old oven works again!!
Parts Used:
-
RICHARD from GLOVERSVILLE, NY
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
10 of 17 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!