The drip pan is found under the burner. This square chrome stovetop drip pan is intended for use with gas ranges. It has a 4-inch diameter center hole and 7 3/4 inch sides. Drip pans should be cleaned regularly, and replaced when too much food has been burned and stuck to it, making it too hard to clean. You should replace your drip pan i...Read moref it is rusted or damaged. Grease, oil, and food can spill into your unit and become a fire hazard. This drip pan is dishwasher safe and is sold individually.
This gas burner grate is used for some gas ranges and cooktops. This is a black burner grate with each side measuring almost eight inches. This part may become rusted or burnt over time if not properly taken care of or with excessive use. If you notice that your grate is discolored or blackening, it may need to be replaced. The surface bu...Read morerner grate provides a steady surface for your cookware that is placed on top of the surface burner. This is a genuine OEM part that is sourced directly from the manufacturer.
This part is found in your gas range, also known as spark electrode. This part helps your burner ignite and produce flame. This will need to be replaced if it is no longer providing spark to start the burner. This may happen because the wire shorted out or the porcelain cracked. To access this, part, you will need to get underneath the co...Read moreok top. You will need to remove the grates and burner heads to do this. Remove the screws that hold the burner assemblies to the cook top. Take a screwdriver to pry up on the cooktop.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Ignitor did not spark when turning the know
9 of 11 peoplefound this instruction helpful.
Richard from Lansing, MI
Easy
15 - 30 mins
Screw drivers
Had to remove the 4 range knobs, and the oven knob and then the facie. Two screws under the end caps and two on each side from the back on each end. Design defect: one of these screws which attaches through the frame to the facie also attaches the support which holds up the range top. Take that one off last. Remove the two wires that atta
... Read morech to the oven light switch. After detaching the power supply to the defective ignition unit, it just pulls right off. Push the new switch on over the knob shaft and reassemble.
Read less
Was this helpful?
Thank you for voting!
loss burner grate
9 of 18 peoplefound this instruction helpful.
Kenneth Coates from Washington, DC
Really Easy
Less than 15 mins
Just set in the new grate and start cooking
Was this helpful?
Thank you for voting!
Left rear burner would not ignite
5 of 7 peoplefound this instruction helpful.
John from Perth Amboy, NJ
Really Easy
Less than 15 mins
Pliers, Screw drivers
Removed the burner plates. Lifted up the range top. Removed the knobs. Unbolted the 2 rounded nuts at top of face plate. Removed the 4 screws that hold the face plate in place from behind. Un plugged the old switch and plugged in the new one and bam! The burner worked. Thanks, Super fast shipping! The part was here in less than 36 hours.
... Read more John, N.J.