Exterior Door Glass - White WB56T10356

Hello Samuel, Thank you for your inquiry. You need a flat blade screwdriver, a 1/4 inch nut driver, and a Torx 15 screw driver. Open the oven door, using the flat blade screw driver, open the hinge locks on both sides, then close the door partially and lift it off the hinges. Place the door with the handle side down on a workable surface. Using the torque 15 screw driver, back up two screws at the top of the door for approximately half an inch. Remove the 3 screws at the bottom trim with the 1/4 inch nut driver and lift the inner door off, then remove the side screws and take the bottom trim off. Carefully remove the old glass from the top trim, then slide the new glass into the top trim groove and the clips. Reattach the bottom trim and the side screws with the 1/4 inch nut driver. Take the inner door and pull the top screw sleeves down, then re-install the inner door and tighten the top screws with the torque 15 screwdriver, and the bottom trim screws with the 1/4 inch nut driver. Slide the door back onto the hinge slots, open the door and lock both stoppers. Hope this helps!