Average Repair Rating: 3.3 / 5.0, 3 reviews.
What's this?
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Fridge was down
Dropped everything mounted to the inside top of the fridge
Martin from HULL, MA
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver
2 of 2 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
REFRIERATOR AND FREEZER NOT WORK ONLY THE INSIDE LIGHTS WOOK AND THE TEMPERATURE WINDOW DO NOT WORK
REMOVE ALL SCREWS ON THE TOP INSIDE OF THE REFRIGERATOR, IT WAS A LITLE BIT TRICKY TO FIND OUT HOW REMOVE THE PLASTIC BECAUSE THEY WAS SOME CLIP AND SLUT HOLE. NEED TO BE A LITLE BIT HANDYMAN TO DO THAT JOB. GOOD LOCK
Joel from SUNNY ISL BCH, FL
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers
4 of 4 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The electronic brain died.
The electronic board died. Found the part and order it. It arrived in two days. I put it in in 15 minutes and fixed a 2000 dollar ref. I am one happy camper. Bob
Robert from Melbourne Beach, FL
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers
33 of 63 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
4 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Glenn
August 7, 2018
The display in the brainbox randomly goes blank turning the cooling action off. When adjusting the refer/freezer control the brain box will randomly shut off. Do i need a new brainbox?
For model number GLHS69EJPB2
Hi Glenn, Thank you for your question. There are two parts that you should take a look at. The touch pad label for your buttons and the electronic control board itself. Unfortunately an electronic control board can only be tested by a certified technician, or if you have the technical sheets that came with your appliance. You could use those to test that part. I hope that helps. Good luck with your repair.
2 people found this helpful.
Was this helpful?
Thank you for voting!
Henry
December 23, 2017
How do I remove the plastic cover to get to the terminal switch board?
For model number PHS69EJSS0
Hello Henry,
Thanks for your question. Remove the screws across the front control box and the screws in the rear control box.
Remove the cover over the water line if needed. The housings over the control board
separate at the rear left by sliding the rear to the right until the buttons line up with
the large slot holes. Disconnect the two thermistors from the top of the control
and disconnect the wiring harness. Push the front of the control box forwards, then slide
the control straight up and out of the housing.
I hope this helps.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Kimberly
June 20, 2019
Refrigerator is running hi (warm)when you try to bump it down it goes off on the control panel
For model number GLHS66EJSB0
Hi Kimberly, thank you for your question. When you are having temperature problems in your fridge, there are a few parts that could cause the issue. You can use a multi meter to test most of the parts. Make sure you cut power to your appliance before doing any repairs or tests. First you should test your defrost thermostat. Place the thermostat in ice cold water for 2-3 minutes after removing it from your appliance. It should be reading 0 ohms to be working correctly. Another part to check would be your defrost heater. Remove it from the appliance. It should be reading anywhere between 0 - 50 ohms to be working. You could check your temperature sensor. To find the correct reading for this part you will have to refer to your tech sheet that comes with your appliance. You can usually find this tech sheet behind the bottom grille of your fridge on either the right or left side. These are the most common parts that cause this issue in your appliance. So it is suggested you check them first. I hope that helps. Good luck with your repair.
Was this helpful?
Thank you for voting!
Wade
July 15, 2019
The light does not work on water/ice dispenser and the button to change crushed or cubed doesn't work. Only dispenses crushed ice. Would the problem be this board? Any ideas?
For model number FRS26RLECS4
Hello Wade, thank you for inquiring. For this symptom you will want to consider either the Dispenser Switch part PS1526359 or the Module Label Cover part PS817741 for your model. We hope this helps.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.