Average Repair Rating: 4.4 / 5.0, 1 reviews.
What's this?
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Unit Would Agitate But Not Spin
First release pressure clips on the top front to release the front cover. (Slid screw driver between top and and front cover). Disconnect connectors to motor. Remove 4 nuts with socket set. Install belt on motor first then while holding belt to flywheel work around to install. Note: the drum will not take off right away, it will wait
... Read more a short while then start and will increase in speed step by step.
Read less
ANDREW from LAUDERHILL, FL
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers, Socket set
36 of 75 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
3 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
GREGG
February 12, 2018
My washer is 12 years old and i can't find the led on inverter board. Motor dose not work. Fills up and drains but wount agitate or spin. Thank you, gregg
For model number GE wpre6100
Hi Gregg,
Thank you for your question. There is only one control board listed under your model number. The part number listed under your model number for the board is PS2350044. I hope this helps. Thank you and have a great day!
4 people found this helpful.
Was this helpful?
Thank you for voting!
Jesse
January 15, 2018
Is there a way to test the drive motor with a voltage / ohm meter?
For model number WBB4500G2WW
Hello Jesse,
Thanks for your question. You will need to use a multimeter to test the sensor on the motor in the multi-plug. Test each connection for continuity and also check the brushes on the motor to see if they are worn.
I hope this helps.
3 people found this helpful.
Was this helpful?
Thank you for voting!
Ray
April 30, 2018
It fills with water but will not wash. If i move the selector switch it will empty the tub. Which terminals do i use to check the motor? Or do you think the board is bad? Help please!
For model number WJRE5550H1WW
Hi Ray,
Thank you for your question. If the washer is not starting, There are some parts that you will need to check to see which ones are causing the issue. You will need to check the start/stop button, the washer mounted control board, the fuse link, the belt and the drain pump. I hope this helps. Thank you and have a great day!
1 person found this helpful.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
