Quick Question!

Have you ever purchased from PartSelect.com before?

2089472-2-S-Whirlpool-7403P307-60-Snap Acting Thermostat
2089472-2-S-Whirlpool-7403P307-60-Snap Acting Thermostat 2089472-1-S-Whirlpool-7403P307-60-Snap Acting Thermostat https://www.partselect.com/Schematics/Maytag/42201.gif

Snap Acting Thermostat

Your Price

PartSelect Number PS2089472
Manufacturer Part Number 7403P307-60
Manufactured by Whirlpool

This part works with the following brands: Magic Chef, Maytag, Kenmore, Admiral, Norge, Crosley, Litton.

This part works with the following products: Range, Microwave Oven Combo, Wall Oven.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.8 / 5.0, 2 reviews What's this?
1-2 of 2

12 of 16 people found this instruction helpful

Parts Used:
Level of Difficulty: A Bit Difficult
Time to do repair: 30 - 60 mins
Tools: Pliers, Screw drivers
Customer: Tom from Independence, MO

Display goes blank,press display it comes back

Display goes blank, had to press hard to get back, other times oven would shut off display flash. again pressing display cleared problem. Replaced display, problem came back but not as bad and only had to press lightly to get back. I then replace relay board & sensor. No more problems. Again, turn pwr off, remove burners & reflectors, mark burner receptacles as to FR-RR-LF-LR, Philips screw driver remove these, pop top, lay wiring forward, remove 4 Philip screws holding cover, angle one side down and pull up other side. should be enough wire to pull from relay board and place on new one, then use needle nose or regular pliers to pinch stand offs so board comes up. Remove two plastic legs, (might be brittle) put on new board, press board down on stand offs. Sensor is obvious. Replace covers, and other items and your done. Nothing really to hard.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1 of 1 people found this instruction helpful

Parts Used:
  • Snap Acting Thermostat
Level of Difficulty: Really Easy
Time to do repair: Less than 15 mins
Tools: Screw drivers
Customer: William from Greenville, AL

The oven would shut off after a few minutes of operation. Just touching the timer or opening and closing the door would usually turn it back on again.

Removed the electrical power. Lifted up the top. Slipped off the two connecting wires. Removed two screws. reinstalled new thermostat in reverse order.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-2 of 2