Ask our experts a question about this part and we'll get back to you as soon as possible!
4 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Darrell
November 23, 2019
Dryer shut off but panel stayed lit up with the time remaining to dry. Let set 10 minutes restarted the dryer and it finished drying. Second load same problem. Please help me out!
For model number Wed8200yw2
Hi Darrell, sounds like a possible bad control board. You can test it with a multimeter. Thank you for your question and good luck with your repair!
Hi James, thank you for reaching out. Yes, this drive motor, part number PS11754878, fits your model. If you require assistance to place an order, please contact customer service. We hope that helps!
Was this helpful?
Thank you for voting!
Donald
September 20, 2023
Replaced door switch and light comes on but drum does not turn on.
For model number MEDB850WL0
Hi Donald, thank you for your inquiry. Based on our understanding of the issue, we would suggest checking the drive belt for any signs of wear or damage. If the belt is in good condition and properly connected to both the drum and motor, then you may need to replace the drive motor, part number PS11754878, to fix the issue. We hope that helps!
Was this helpful?
Thank you for voting!
Eric
January 10, 2024
Hi,
I believed the motor is dead, but I am not 100% sure.
The dryer light up, but nothing happen when you press start.
How can I test the motor before I order a new one?
Also, mine have 2 pulleys, one on each end. From the research I did, they are not showing a 2 pulleys motor. Do I have to remove the pulley from my old motor?
Thank you
Eric
For model number YWED8400YW2
Hello Eric, thank you for your inquiry. Based on the description that you have provided, we would recommend checking the drive motor, part number PS11754878, to fix the issue. The drive motor contains both of the pulleys. You can test the old motor using the following instructions:
1. Rotate the multimeters range selection dial to the lowest setting for ohms of resistance.
2. Connect the black meter lead to the motor protector terminal, and the red lead to the start winding wire terminal.
3. If the meter display shows two to five ohms of resistance, the drive motor start winding has electrical continuity.
4. Keeping the black meter lead on the motor protector terminal, move the red meter lead to the run winding wire terminal to see if that has proper electrical continuity.
5. If both windings show two to five ohms of resistance, the motor has continuity and should be functioning properly.
6. If the display does not change when testing, the motor has no continuity and you will know it is defective.
We hope this helps!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
