Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
March 7, 2019
Both ovens gets an error code f8eo and shuts down. What does this mean and what is
Required to repair
For model number jjw2830ws02
Hello Ray, thank you for your question. That error code is in regards to the cooling fan. The cooling Fan Speed Too Low Fan speed below 500 rpm, may be caused by either because the fan spinning too slowly or because there is a problem with the Hall Effect sensor. Here are some steps to help determine what the issue is. 1. Unplug range or disconnect power. 2. Pull the range forward and remove the top access cover. 3. Verify there are no obstructions in the blower. If there is an obstruction, remove it and go to Step 6. If no obstructions, go to Step 4. 4. Disconnect control board connector P5 and check the fan motor for 105 Ohm resistance between P5-1 and P6-3. If the motor test is not good, replace motor and go to Step 6. If motor tests good, go to Step 5. 5. Check the Hall Sensor by removing the control board P7 connector and testing for 5 VDC between P7-7 and P7-1. If test is good, go to Step 6. If test results are not correct, replace the Hall Sensor. 6. Replace all parts and panels before operating. 7. Plug in range or reconnect power. 8. Start a cook cycle and check for proper operation. 9. Enter the diagnostic mode to view the “Faults” screen. Press START TIME or DELAY START to clear each Fault code(s). I hope this helps!