PANEL-REAR WP3357978

Hi Gerald, Thank you for your inquiry. The model number for your washing machine can be found in few locations. You will need to check in the upper left hand corner on the back, on the back of the control panel, under the lid, inside the tub in the back right corner along the rim, the lower left hand corner on the front. If you have a front loaded washing machine look along the rim of the door of where the door shuts onto, check the bottom left or right hand side of the washer and check on the kickplate at the lower front. I hope this helps. Thank you and have a great day!

Hi Donald, Thank you for the question. If you wish to order the rear panel, please feel free to process the order online or by giving us a call. Look forward to hearing from you!

Hi Jerry, Thank you for your question. If hot water is just dribbling into the washer, there may be an issue with with the water inlet or the inlet hoses. You will need to inspect the parts and verify which one is causing the issue. For the hoses check the Before starting this inspection, ensure that you have disconnected your washer from both the power and water source. In order to remove the valve for testing, you will need to remove all or part of your washer’s cabinet. The valve should be found directly behind the hose connections. Looking for signs of damage, cracking, or wear, visually inspect your washer’s valve. The valve has screens inside it that may have built up dirt or debris, if so, it should be carefully cleaned as if these screens become damaged, you will need to replace the entire valve. The resistance of a properly functioning valve varies from model to model, refer to your owner’s manual to determine what the reading of your test should be. To test for continuity, place the probes onto the valve’s terminals with your multi-meter set to Rx1. If you do not receive a reading that indicates continuity, you will need a replacement water inlet valve. For the hoses, begin by checking that the hoses are not kinked and that the faucets are fully open. Turn the faucets off, disconnect the fill hoses from the inlet valve, and inspect the screens that are a part of the valve. Remove any sediment or debris you find. To verify that you have adequate water pressure to fill the hoses, place the hose ends in a bucket or tub and turn the faucet on. If you have minimal pressure, inspect the screens in the hose for dirt buildup or damage. If you come across issues while performing these inspections, you will need replacement hoses & screens. You should also check the lid switch, the water level pressure switch and depending on your model, you will need to check either the timer or the electronic control board. We hope this helps. Thank you and have a great day.

Hi Nicco, Thank you for your question. If the agitator is not attached correctly, you will need to inspect the agitator and see where the problem is. Here is a link to one of our videos from YouTube that you may reference on how to remove/install the part, https://www.youtube.com/watch?v=iYcmcX2sstg. The washer and agitator in the video may not show exactly like the one you have, but it will give you a general idea on how to remove/install the part. We hope this helps. Thank you and have a great day.