Ice Bucket Auger W10822606

Hello Leland, Thank you for your inquiry. Yes, this would be the correct part number for the motor to activate the auger and blades. We have found the following installation instructions: remove access panel and disconnect the wire. Remove the 4 screws that hold the motor in place. Place rubber washer (that is supplied with new motor) onto shaft. Replace new motor and connect wire then install access panel. Hope this helps!

Hi Frank, Thank you for the question.I suggest removing the motor to tray and unthaw it first.Here are a few things to check that might cause the motor to freeze up.Check for an air leak or gap in the door gasket. You can also check the dispenser door for an air leak, and the ice dispenser flapper door for proper closure and seal. Make sure the freezer compartment isn't too cold, the average temperature should be 0 to 5 degrees. Hope this helps!

Hello, Thank you for your question. I would look into the motor, because it if it not allowing any ice through then that could be why if the motor is not turning. We hope this helps.

Hi Kevin, Thank you for the question. Unless there is visible damage to the wire harness, you should be able to replace just the motor assembly.Hope this helps!

Hi Thomas, thank you for your question. It is likely then that you will have to replace your motor. However you may want to take a look at your auger shaft and make sure it has not stripped. You could also take a look at the micro switch on your dispenser area as well. I hope that helps. Good luck with your repair.

Hello Phil, Thank you for the question. If there is no damage or wear tot he shaft or washers, it is recommended to replace the motor. Thank you for your inquiry, good luck with this repair!

Hello Annette and thank you for writing. Actually we have, it turned out to be the water inlet valve being faulty. The model number you provided is not recognized. Please verify the number you provided us. If it is correct, we recommend contacting the manufacturer and seeing if they could provide you with a part number, and then you are always welcome to check back to see if we carry the part! We hope this helps. Please contact us anytime if you require further assistance.

Hello Ross, Thank you for the question. This is number 28 only in the Diagram, Ice Bucket Auger Motor. We hope this helps!

Hello Barry, thank you for your question. There could be a few things causing your dispenser to not dispense ice. It could be that your ice is frozen into chunks that the auger cant break apart or push out. In this case you would have to defrost the icemaker. If the auger is not turning at all, you should verify the motor is operating. Part number PS733947. You can check it for continuity with a multi-meter. Remove power from the appliance before performing this test. If the motor has continuity then you should inspect the actuator, part number PS11749101 and switch, part number PS11738948. Remove the control panel cover and verify that the actuator contacts the dispenser switch properly and if not, check the actuator housing bracket, switch mounting bracket and the actuator pivot. Replace any defective parts. If the actuator is contacting the switch, you will need to check the switch. Set your multimeter to the lowest ohms of resistance and test your switch. If it does not read any continuity, then your switch is indeed faulty. If all of these parts check out we recommend replacing the control board. Part number PS11749617. We hope this helps.

Hello Paula, thank you for your question. We have researched the model you have provided, and we would suggest the Ice Bucket Auger, part number PS11723175. If you need help placing an order, our customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!