ZVB36B1WW General Electric Range Hood - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Controller board fried
Disconnected power and removed electrical cover
Disconnected wires from old controller one a time and connected to new controller as to not mismatch wire connections. Left new controller hanging off wires.
Raised vent and held using wood blocks to expose gap to use 1/4 inch wrench to undo screws from the inside (poor design for replacing the controller - this was the bulk of my time.) if this didn't work, I would have had to disassemble more of the downdraft.
Installed new controller.
Removed chocks, enabled power and tested...after verified, re-installed electrical cover.
Disconnected wires from old controller one a time and connected to new controller as to not mismatch wire connections. Left new controller hanging off wires.
Raised vent and held using wood blocks to expose gap to use 1/4 inch wrench to undo screws from the inside (poor design for replacing the controller - this was the bulk of my time.) if this didn't work, I would have had to disassemble more of the downdraft.
Installed new controller.
Removed chocks, enabled power and tested...after verified, re-installed electrical cover.
Parts Used:
-
Anthony from Stevensville, MD
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Wrench set
6 of 8 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!