Parts That Fix Whirlpool Refrigerator WRF757SDHZ00 Ice maker won’t dispense ice
Ice maker won’t dispense ice is a commonly reported symptom for the WRF757SDHZ00 Whirlpool Refrigerator, and we have put together a full guide on how to fix this. This advice is based on feedback from people who own this exact appliance. We have listed the most common parts for your WRF757SDHZ00 Whirlpool Refrigerator that will fix Ice maker won’t dispense ice. We have included repair instructions, and helpful step-by-step video tutorials. If you are experiencing this issue, not to worry, DIYers just like you have fixed this, and shared their experience to help you!
This part is a replacement refrigerator drive shaft seal for your refrigerator. The drive shaft seal protects the auger motor from water and condensation that may leak down the drive shaft from the ice bucket. If the seal is broken, water and condensation can get in, causing the ice maker to fail. To replace the seal, first remove the ice bucket from your freezer. Then remove the two screws on the drive shaft holder, and use a pair of pliers to remove the drive shaft. At this point you can remove the seal from the drive shaft. Be sure to clean the area that the seal sits in before you reinstall the drive shaft. This part is white in color and is about an inch in diameter. The seal is sold individually.
This auger motor is for refrigerators. Auger motor turns the auger that pushes the ice cubes through the dispenser chute. Safely store any food that could deteriorate while the power is off. Unplug the refrigerator before installing this part. Wear work gloves to protect your hands.
Customer Repair Stories
Ice Augur Motor not Working
-
Mark from WISC RAPIDS, WI
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver
Ice dispenser motor burnt out, water got inside.
-
Blye from Victoria, VA
-
Difficulty Level:Really Easy
-
Total Repair Time:1- 2 hours
-
Tools:Nutdriver, Screw drivers
This ice container, also known as an ice bucket or ice bin, is an authentic OEM part that is designed to fit with refrigerators. It consists of a white base attached to a transparent plastic dish with a metal rod in the center known as an auger. It is where produced ice is collected and stored. The container serves as a reservoir for the ice and allows for convenient access to ice cubes or crushed ice whenever needed. It also prevents the ice from scattering throughout the freezer compartment. If you notice water leakages, visible damage on the ice container, experience difficulties dispensing ice, or notice ice clumping together in large masses, then you will likely need to replace the container.
Customer Repair Stories
Getting the second part assembled, should have been pre assembled
-
Ralph from Tequesta, FL
-
Difficulty Level:Very Difficult
-
Total Repair Time:More than 2 hours
-
Tools:Screw drivers
Hole in container
-
Kevin from VALDOSTA, GA
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
Customer Repair Stories
Ice dispenser motor not working
-
Walter from MYRTLE BEACH, SC
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Screw drivers
This light switch may also be known as a refrigerator door switch or a light switch kit, and is compatible with your refrigerator. The function of the refrigerator door switch is to turn on the light when your fridge door is open, and to make sure it is off when your refrigerator door is closed. The reason you would need to replace this part is if your light is not turning on when your door is open. For this repair, you will need a putty knife, and a small flat-blade screwdriver.
Replacing your Maytag Refrigerator Door Switch
Customer Repair Stories
Light switch rocker broke, disabling freezer internal light, water dispenser, and ice dispenser
-
Kenneth from Newton Grove, NC
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
while closing the door, the light switch fouled, resulting in the switch breaking
-
Kevin from Beckley, WV
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers