Ask our experts a question about this model and we'll get back to you as soon as possible!
3 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Gord
February 15, 2020
Washer is not entering final spin. Just spins out slowly & everything is sopping wet. Pump is functioning. Pump motor ohms out low.
For model number WCXH208A0WW
Hello and thank you for writing.
It certainly sounds like it could be a faulty PS10055431 you should check the part(s) for signs of damage and replace the part(s) as needed. We hope this helps. Please contact us anytime if you require further assistance.
Can the detergent/bleach/softener drawer be removed entirely for cleaning?
For model number WCXH208A0WW
Hello Stephanie, Thank you for the question. There should be a tab at the back of the drawer that clips into the drawer housing. Push the tab down and it will release the drawer and you can remove to clean. We hope this helps!
Was this helpful?
Thank you for voting!
Deepak
January 3, 2020
I am looking for spider arms for drum
For model number WCXH208A0WW
Hi Deepak, sadly the requested part is discontinued, however you can contact the manufacturer to see if they have a suggested replacement. If they can provide you with a part number feel free to contact us back to see if we have the part in stock. Thank you for your question and good luck with your repair!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
I paid a plumber $150 to replace this part a year ago. I simply took the screws out,ordered the part,paid for 1 day shipping, and screwed the new part on. The washer DID NOT WORK without this part,and worked perfectly the minute I replaced it.
Very simple! Found the part using the diagrams and photographs on this site. When it came, my husband ust pulled the remainder of the broken knob off the little post with a pair of needle-nosed pliers. Slid the new knob on. It took longer to find the pliers than to make the repair!
I began by removing the seal from the exterior lip of the machine housing. I took a razor and removed any rubber and adhesive that remained on the unit.
Next, I remove the boot from the soap dispenser tube (located at about 11:00 of the opening) with a needlenose plyers. The manual recommends flattening a 3" copper pipe to
... Read more fashon a tool to release the "bread tie" fastener. I can see why but patience with a needlenose sufficed.
I pulled the boot down from the tub housing (with much force) exposing the band that holds the boot in firmly. I one pull, both pieces came out. I could tell getting the new one is was going to be a chore.
I cleaned the area and after about 40 strenuous minutes of getting the new boot onto the tub, only a couple things remained. Even with help, be prepared to dedicate hours of frustration getting the band around the boot securing it to the tub. The working space is minimal and the task is virtually hopeless to slightly possible.
Once that's taken care of, you may feel like you can accomplish anything. The rest goes up in the order it came out. Make sure you slide the boot up as far up the soap dispensing unit as possible before securing the bread tie clamp.
Run the seal around, close the door and have one of you kids clean up the work area (and mop the blood, sweat and tears from the unit and the floor.
