WA50F9A6DSW Samsung Washer - Instructions

Shut off water and electrical supply to appliance, take water supply hoses off to allow for proper access to back of machine.
Take off back panels of appliance. Disconnect two hoses from pump. Take out two screws which attach pump to washer body. Detach wiring which connects pump to control unit ( that takes a little time). Install pump in designated location, connect hoses, connect wiring to control unit, connect appliance to powere source, test run to make sure everything works properly, make final detailed wire connection Pump to control unit, install back panels, Connect water supply hoses .....and be proud of yourself!

Though I could hear and feel the drain pump running, the washer would not drain. This model does not have a filter for the drain pump. I lowered the discharge hose from the stand up pipe on the wall, and lowered it to the floor. Water ran right out, so no blockage in the drain system. After removing the inlet and outlet hoses to the pump, a quick inspection showed the impeller on the motor was off the shaft and flopping around. Bingo, motor runs but cant pump.
Ordered from Partselect and received in ONE DAY. I really didn't want to go back to it that soon, but they certainly did their part. Ha. Thank you all. Greg

Just snapped on part in the center of tub where it belongs

Had to drill out the rivets on the back top panel to get the wires to thread back the same way. Poor design by Samsung. They should have used bolts to secure the back top panel or have some kind of coupler in the wiring.

NOTE: this repair requires OEM part number DC60-50003A and what was originally provided was 6021-001573. This is important as Part Select has this mixed in their Database and I made them aware.

Otherwise once you have the correct part the repair is simple. Open the top of the washer and remove the pulsator cap, there is a 10mm bolt which is removed next, the pulsator pan (believe this is correct) can be removed with a flat head screw driver. Do so by placing the screw driver in one of the groves by where the bolt was. Once this is removed that is where this part will be. I didn’t have to remove since mine was in pieces but it comes off/goes on counter clockwise. Repeat steps to put everything back together.

Snapped the replacement cap in place.

Insert Tabs A into Slots B. Twist.

Nothing to it, just aligned the three pins on the new cap and gently
pushed down.

Went to YouTube video and followed instructions.

Hardest part was making sure water from hose does not flood floor while taking it off from water pump and letting water drain in bucket.

See YouTube video

https://youtu.be/oOnxbj-unfc?si=OFFwOcNiIymh_9b-

Squeezed clamp with fingers to remove old drain hose. Put clamp on new replacement hose and slid over drain pipe and released clamp. Less than a minute. Hose was exact replacement part.