WA456DRHDSU Samsung Washer - Instructions

Shut off water and electrical supply to appliance, take water supply hoses off to allow for proper access to back of machine.
Take off back panels of appliance. Disconnect two hoses from pump. Take out two screws which attach pump to washer body. Detach wiring which connects pump to control unit ( that takes a little time). Install pump in designated location, connect hoses, connect wiring to control unit, connect appliance to powere source, test run to make sure everything works properly, make final detailed wire connection Pump to control unit, install back panels, Connect water supply hoses .....and be proud of yourself!

Though I could hear and feel the drain pump running, the washer would not drain. This model does not have a filter for the drain pump. I lowered the discharge hose from the stand up pipe on the wall, and lowered it to the floor. Water ran right out, so no blockage in the drain system. After removing the inlet and outlet hoses to the pump, a quick inspection showed the impeller on the motor was off the shaft and flopping around. Bingo, motor runs but cant pump.
Ordered from Partselect and received in ONE DAY. I really didn't want to go back to it that soon, but they certainly did their part. Ha. Thank you all. Greg

Tipped the washer up on a couple of chairs. Pulled the motor apart in three pieces and replaced the Hall Sensor. Error code lead me right to the problem and solution.

Went to YouTube video and followed instructions.

Hardest part was making sure water from hose does not flood floor while taking it off from water pump and letting water drain in bucket.

See YouTube video

https://youtu.be/oOnxbj-unfc?si=OFFwOcNiIymh_9b-

Squeezed clamp with fingers to remove old drain hose. Put clamp on new replacement hose and slid over drain pipe and released clamp. Less than a minute. Hose was exact replacement part.