Models
>
SRM-300E
SRM-300E Echo Trimmer - Overview
Sections of the SRM-300E
[Viewing 3 of 3]
Keep searches simple, eg. "belt" or "pump".
Fuel Filter
PartSelect #: PS11826311
Manufacturer #: A369000480
This OEM Fuel Filter is a silver and white, steel/felt, part measuring about 1.25 inches in length and 3/4 inch wide. It can be installed with pliers and is rated as Easy to install by customers.
Th...
$5.36
In Stock
Nut-Lh Thread
PartSelect #: PS9308872
Manufacturer #: 90051100010
The m10 Left Hand Thread Nut is a 10mm, gold metal part, sold individually. This nut is a "reverse thread". It requires a wrench or socket set to install, and installation is rated as "Easy". Use this...
$5.19
In Stock
Split Pin 2x22
PartSelect #: PS9162863
Manufacturer #: 90030020022
The Cotter Pin (or Split Pin) is a 2x22mm silver metal part, sold individually. It is rated as "Easy" to install, and installation will require a set of pliers. It can be attached in various locations...
$4.99
In Stock
Nut 5
PartSelect #: PS9148697
Manufacturer #: 90050000005
This OEM nut is a 5mm, gold, metal nut, which is sold individually. It can be installed with a Wrench or Socket and Torque Wrench by torquing to the manufacturer specifications. This nut is used to se...
$4.99
In Stock
Spark Plug Cap Spring
PartSelect #: PS9263507
Manufacturer #: 15901103432
This spark plug wire, also known as a spark plug coil or spark plug cap coil, is compatible with various makes and models of hand-held outdoor power equipment and is sold individually. This wire is in...
$5.19
In Stock
Fixture-Blade
PartSelect #: PS9206764
Manufacturer #: C535000150
The Blade Fixture is a silver, metal, individualy sold blade, which attaches at the bottom of the cutting head assembly, being held on by the nut and cotter pin. It is used to secure the blade fixing ...
$9.06
In Stock
Questions And Answers for SRM-300E
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Cracked grips and worn shield
Cut off old grips. Remove throttle trigger by disassembly. Disconnect cable from trigger. Lubricate new grips with soap and water to facilitate sliding grips onto handle bar. Reassemble cable and trigger. Reinstall trigger assembly onto handle bar in original position. Check trigger operation, making sure throttle operates fully closed an
... Read more
d open.
Read less
Parts Used:
-
David A from Lincoln, VT
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers, Wrench set
Was this instruction helpful to you?
Thank you for voting!