Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Refrigerator not cooling properly
Remove shelves then at bottom is a cover that holds fan in place remove a total of 6 screws. 2 of them are behind lamp lens cover you have to remove lamp lens to see them. Then use hair dryer to melt ice to allow cover to come off. Slow remove cover top left side there are two connector you have to disconnect. Then there are 4 screw to pull fan Assy from cover. 1 screw to get to fan motor.on fan cage remove coil spring then pull cage of . Then unplug connector from fan motor. Note to clean drain hole I use a small hose/ funnel and warm water to open hole back up.
Watched YouTube video. The one where the repair guy took the entire assembly out of the door and worked on a flat surface. Went exactly as shown in the video.
We misplaced the mounting screws for our handles while moving.
It was easy! I just used an alan wrench to losen the side bolt, then slid the handle into the new mounting screws that I had hand-screwed and then tightened it all up.