RF260BEAESG Samsung Refrigerator - Instructions

This is the Samsung French door refrigerator style that so many people have complained about freezing up and not cooling the top section. I first changed out the defrost thermostat and this did not correct the problem. I done a quick resistance check on the temp sensor that's mounted on the evaporator itself. The resistance would change when holding an ice cube on the sensor so I just assumed it was ok. PLEASE TAKE NOTE: When performing a resistance check on this sensor, make sure your readings match the Samsung temp/resistance chart in their literature. My sensor was way off calibration and was causing the freeze up. Its working as designed now and DW is happy again. Learn from my mistake.

unlock filter with pliers with a turn to the right, pull out and replace filter, Turner new filter to the left until it click in.

Interestingly, the few authorized samsung parts suppliers I found declared that this model did not have a lower icemaker, whereas this company actually had the specific part. The heater swap is completely straightforward, and simple, but for one detail. The insulation wrap is easily torn when pulling the tube out and my time was spent finding a suitable material to patch the hole. I would recommend purchasing a new tube with heater element and wrap pre-installed. This issue in no way diminished my satisfaction with the product or the prompt delivery time.

OPENED THE LEFT SIDE REFRIGERATOR DOOR WHERE THE DEFECTIVE MECHANISM WAS. GOT UP ON THE FIRST STEP OF THE STEP STOOL,REMOVED THE PHILLIPS HEAD RETAINING SCREW FROM THE BROKEN PART.PUT THE NEW CLOSING MECHANISM IN PLACE AND RE-INSTALLED THE PHILLIPS HEAD SCREW. STEPPED DOWN FROM THE STEP STOOL AND SHUT THE REFRIGERATOR DOOR.

Took out the screw, removed the broken part, put new part on, put retaining screw back in.

Simply drop in new door shelf. IMPORTANT: Be sure to order left or right shelf: they are not interchangeable. Note that left or right door means when you are facing fridge.

Slide Crisper Shelf in and snap into place.

Removed shelves. Removed back cover. Removed old sensor. Installed new sensor. Replaced back cover. Replaced shelves. Works fine.

It was easy! I just used an alan wrench to losen the side bolt, then slid the handle into the new mounting screws that I had hand-screwed and then tightened it all up.

The replacement was fairly simple. I removed the existing tray and detached the water line. Once the water line water reattached to the new tray I inserted into the ice maker.

*** The problem I'm having now is the water is not filling up the tray***
Not sure what I did wrong? Any help would be greatly appreciated!!!