We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
3 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Ms
October 24, 2023
I need the support that holds the lint filter in place.
For model number RDE350AW
Hello Ms, thank you for reaching out. The lint filter support for your model is part number PS12582812. Glad to be of help!
Electric dryer will not shut off even when switch is turned to off or door is opened.
For model number RDE350AW
Hello Terry, thank you for the question. Based on our understanding of the issue, we would recommend checking the door switch by doing the continuity test. If the issue still occurs, you may need to replace the control board, part number PS12343004, to fix the issue. We hope this helps!
Hello Michael, thank you for reaching out. You may need to check the thermal fuse, part number PS12342923, to fix the issue. We hope this solves your problem!
They sent the wrong part even though I gave the unit model number and part number of the part.I described the part and gave the name used by the manufacture on the schematic from the back of the unit. The second person I spoke with to reorder the correct part took more time in understanding that a temp limiter is not the same as a temp se
... Read morensor. The part is located on the inside back wall of the dryer behind the drum. It all had to come apart to get to it but was very easy even without the service manual.Unplug the unit. Remove the 4 screws on the back that lock down the top and pop off the top prying against the spring clips, move it out of the way but remember that its still connected by wires on the inside of the back. disconnect the 2 wires going to the door switch. Remove the two screws holding the front panel on located on the top. Pull up on the panel lifting it off of the spade brackets. Reach in down below and remove the belt from the pulley and drum. Pull up on the drum about 1" and the drum will be free. remove the drum. In the upper right hand corner is where you will see the temp limiter. Remove the 2 screws and unplug the wires. Assembly is the reverse order except to install the belt remove the access panel on the lower left corner of the back of the unit to gain access to the belt for installation....
