Models
>
PRL486GDH
PRL486GDH ((06)) Thermador Range - Overview
Sections of the PRL486GDH
[Viewing 1 of 1]Keep searches simple, eg. "belt" or "pump".
Bake Igniter
PartSelect #: PS8722793
Manufacturer #: 00492431
If your gas oven is not heating at all, or not heating properly the most commonly problem is a faulty igniter. The bake igniter is used in gas overs and ranges, the element in the igniter gets hot eno...
$141.16
In Stock
SWITCH
PartSelect #: PS8714254
Manufacturer #: 00428049
This OEM control panel switch, also known as a limit switch or limit sensor, is mounted within the control panel housing on ranges. It is a small component that is responsible for transferring power t...
$20.14
In Stock
Range GRILL PLATE SMOOTH
PartSelect #: PS10061184
Manufacturer #: 11003854
This griddle is for ranges. Griddle fits over a burner or element and provides a flat cooking surface.
No Longer Available
Questions And Answers for PRL486GDH
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the PRL486GDH
[Viewing 4 of 4]Will Not Start
Fixed by
these parts
these parts
Show All
Little to no heat when baking
Fixed by
these parts
these parts
Show All
Gas igniter glows, but will not light
Fixed by
these parts
these parts
Show All
Element will not heat
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Four extra Low burner igniters malfunctioned, Sparking when burner off.
The sole review for this part by Andrew was most helpful and accurate with one exception: he said that there were two nuts Which needed to be removed in order to pull off the front knob panel. There were actually two on each end for a total of four, which confused me, as I wondered if I had the right ones. Another thing that would be help
... Read more
ful for somebody considering doing this repair is to know that it takes a deep quarter inch socket With two 6 inch extensions to reach these nuts through holes in the interior side panels. Also, take a look at the replacement potentiometers, and you’ll see that there’s a slot that can be lined up so that they can be pulled off the side of the shaft rather than off the front of the shaft. This repair took me about six hours. I’m mechanically inclined and work methodically, but since I’ve never done this repair before it was quite time-consuming.
Read less
Parts Used:
-
Robert from GREENWOOD VLG, CO
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:More than 2 hours
-
Tools:Nutdriver, Socket set
3 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!