If your gas oven is not heating at all, or not heating properly the most commonly problem is a faulty igniter. The bake igniter is used in gas overs and ranges, the element in the igniter gets hot eno...
$141.16
In Stock
Order within the next 5 hrs and your part ships today!
This spacer kit, also known as a grate foot kit, is a set of four padded feet designed to protect your burner grates and prevent scratches on the cooktop. Typically located at the bottom corners of th...
$31.04
In Stock
Order within the next 5 hrs and your part ships today!
This authentic OEM venturi tube, also known as a gas tube connector or surface burner tube, mixes gas and air to create the proper fuel-air mixture for combustion in your range. It is typically locate...
$62.26
In Stock
Order within the next 5 hrs and your part ships today!
This nut is designed for use with different makes and models of ranges and cooktops and is a genuine OEM part. This nut is 1mm thick and is 22-threads-per-inch, and is made of high-quality, durable st...
This OEM control panel switch, also known as a limit switch or limit sensor, is mounted within the control panel housing on ranges. It is a small component that is responsible for transferring power t...
$20.14
In Stock
Order within the next 5 hrs and your part ships today!
The sole review for this part by Andrew was most helpful and accurate with one exception: he said that there were two nuts Which needed to be removed in order to pull off the front knob panel. There were actually two on each end for a total of four, which confused me, as I wondered if I had the right ones. Another thing that would be help
... Read moreful for somebody considering doing this repair is to know that it takes a deep quarter inch socket With two 6 inch extensions to reach these nuts through holes in the interior side panels. Also, take a look at the replacement potentiometers, and you’ll see that there’s a slot that can be lined up so that they can be pulled off the side of the shaft rather than off the front of the shaft. This repair took me about six hours. I’m mechanically inclined and work methodically, but since I’ve never done this repair before it was quite time-consuming.