This OEM Gasket Rocker Cover, which can also be called the Valve Cover Gasket, is used to provide a seal between the valve cover and engine. This is a gray-colored part, measuring 5 1/2 x 4 Inch, and ...
This OEM Seal-Oil (PTO Side), also called the Oil Seal, is a Black, Nitrile Rubber, 2/14 O.D., individually sold part which is installed using a Seal Puller. Customers rate the installation difficulty...
This is a replacement cylinder head gasket for your small engine. It is approximately 5 inches in width and 6 inches in length. The cylinder head gasket helps to create a seal for the cylinder head. I...
The Oil Seal is a manufacturer-approved rubber part which provides a seal between the crankcase and crankshaft by attaching around the axle shaft on the crankhouse housing. Installation is rated as "M...
This OEM exhaust gasket in lawn and garden equipment creates a seal between the engine block and the muffler or exhaust pipe so that exhaust gases do not leak. This is 3.30cm in diameter and 6.35cm in...
The Seal-O Ring, also known as the gasket, is red in color, made of rubber, and is an OEM part that requires some skill to replace. This part is designed to create a seal between the carburator and ma...
I went to Troy-Bilt first first for the part-nothing, then B&S engine, still no help surfing their websites for this part. Again, no help. Before giving up completely I thought about all the parts I have bought from PartSelect for washers and such. Typed in "Fan-Flywheel" B&S. First thing that popped up was a picture of this part. All my
... Read more searching on Troy-Bilt mower site and B&S site for over two hours with no results, and then I go to PartSelect and without my model number or anything else, they had it and even displayed my model number and sent it right away, popped it in and the mower is working fine as ever. No matter what you need, I say save yourself a lot of time and just go here first. I'm a loyal member of PartSelect for over six years!!!
First I opened the top of the mower to expose the housing cover. Secondly I removed the four housing bolts to remove the housing cover from the mower. Next I removed the tube breather and installed the new tube breather and replaced the housing cover with the four bolts previously removed and closed the top of the mower. I filled the mow
... Read moreer with gas to check for leaks which weren't any leaks. I proceeded to mow the lawn with ease.
