Models > NNT176K AC21A

NNT176K AC21A Norge Refrigerator - Overview

Sections of the NNT176K AC21A

[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".

Questions And Answers for NNT176K AC21A

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Common Symptoms of the NNT176K AC21A

[Viewing 9 of 9]
Light not working
Fixed by
these parts
Show All
Fridge too warm
Fixed by
these parts
Show All
Noisy
Fixed by
these parts
Show All
Freezer section too warm
Fixed by
these parts
Show All
Leaking
Fixed by
these parts
Show All
Fridge runs too long
Fixed by
these parts
Show All
Will Not Start
Fixed by
these parts
Show All
Fridge and Freezer are too warm
Fixed by
these parts
Show All
Fridge too cold
Fixed by
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sometimes the condenser fan would start causing the refrigerator to overheat.
Unplug the appliance.
Removed the screws holding the back panel.
Removed the fan blade.
removed 3 screws holding the condenser fan.
Remove the 3 metal brackets attached to the fan.
(First note which studs the brackets are attached to. Attach the 3 metal brackets to the new fan. (New screws were supplied)
Cut and strip the wire about two inches from the fan.
Cut and strip the new wire. I cut the new wire in half (about 6 inches.) Connect the two wires, twist and used 2 wire nuts. Tie wrap the wire to the wire harness. Mount the new fan (three screws)
Screw the back panel back on.
Mount the new
Parts Used:
Condenser Fan Motor Kit
  • Tom from Franklin, WI
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Pliers
166 of 179 people found this instruction helpful.
Lights inside refrigerator not working
I used a flat-head screwdriver to pop out the old light rocker switch. Then, I unplugged the wires, plugged them into the new light rocker switch, and then popped the new switch into the hole. That's it! Lights began working again.
Parts Used:
Refrigerator Door Switch
  • Clint from Rayville, MO
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
89 of 104 people found this instruction helpful.
cocktails running out of ice
filled both ice cube trays up with water and placed in the freezer.. within hours my ice oproduction was doubled! no more warm cocktails : )
Parts Used:
Ice Cube Tray
  • Craig from Westminster, CA
  • Difficulty Level:
    Very Difficult
  • Total Repair Time:
    More than 2 hours
  • Tools:
    Nutdriver, Pliers, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
52 of 57 people found this instruction helpful.