Parts That Fix Maytag Washer MVWX655DW0 Leaking
Leaking is a commonly reported symptom for the MVWX655DW0 Maytag Washer, and we have put together a full guide on how to fix this. This advice is based on feedback from people who own this exact appliance. We have listed the most common parts for your MVWX655DW0 Maytag Washer that will fix Leaking. We have included repair instructions, and helpful step-by-step video tutorials. If you are experiencing this issue, not to worry, DIYers just like you have fixed this, and shared their experience to help you!
The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installation, you will need a flat head screw driver to replace the clamp and a drill to access the screws to remove the front of the washer. Be careful if you do not have specific clamp pliers as the clamp could fly off. Once the front of the washer has been removed, take a quick look for water damage or any obvious signs of where the leak is coming from. If it is not obvious, run water to test.
Replacing your Kenmore Washer Hose Clamp
The drain hose carries used water from the washer to your house drain.
Replacing your Whirlpool Washer Washer Drain Hose
Customer Repair Stories
Replace drain hose
-
Brian from DREXEL HILL, PA
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers
replaced drain hose that was missing
-
Delmar from EAST TROY, WI
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers
Replacing your Whirlpool Washer Hot Water Valve
This is the replacement cold water inlet valve for your washer. It is mainly blue in color and has two solenoids. The water inlet valve in your washer connects to the water source and solenoid wires, and ensures the tub has the right amount of water entering it. If your washing machine continues to fill after it is full, or if it fills slowly, you may need to replace this valve. Before you begin this repair, be sure to disconnect the water and power sources from your washer. This part is sold individually and is an authentic OEM part.
Replacing your Whirlpool Washer Cold Water Valve
Customer Repair Stories
Water kept running
And very impressed with the fast quick delivery of the part thank you very much
-
Marco from LIPAN, TX
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Socket set
COLD WATER WOULD NOT SHUT OFF
-
Robert L from Pleasanton, CA
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Socket set
This clamp helps to prevent leaking by holding the end of water hose in place.
