All Installation Instructions for Husqvarna LGT2654

Drive belt came off from transaxle pulley, noticed in bad shape, ordered new one form parts select.

The drive belt literally goes from the back of the tractor to the front. The mower must be removed, helps to have the tractor up on blocks to give adequate room for work on underside. Belt goes easiest on the engine first, then thread to the rear, install on the rear, (driven pulley) then on the idlers. Check to assure that it functions properly before re-installing the mower. If you have the owners manual, there is a diagram, (check your orientation, it is not clear if it is a birdseye or under tractor view) which offered some help. When replacing belt, check the transaxle front mount, mine was broken which is why the belt came off in the first place. Repairing the mount was quite a job in itself, but now works fine.

Parts Used:

V-Belt-Drive

Lynn from BOILING SPGS, PA
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Socket set

17 of 27 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Wheel bushings were bad

Removed old clip removed rim from tractor, removed grease fitting on rim, took hammer and screw driver knocked out old bushing turned rim over knocked out other bushing. Press in new bushings reinstalled grease fitting slide tire back on tractor, put retaining washers on then locking clip put on dust cover grease at grease fitting. Repeat other side.

Parts Used:

Ring Klip Number T5304-75

Cap Axle Black 1 50 x 1 00

Anthony from OLIVEHILL, TN
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers

12 of 20 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Broken weld on right axle

Removed wheel (used strong magnet to catch the keeper)
Removed axle assembly from its mounting tube
(used strong magnet again to prevent keeper lose)
Installed replacement axle (again with the magnet)
Lubricated with 90 SAE
Re-installed the wheel (used magnet again to hold the keeper.
Mowed the lawn.

Parts Used:

Spindle Asm.-RH

walter from EDINBURG, VA
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Socket set

1 person found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Original shield was damaged

Removed original shield ( 2 bolts), replaced with new shield.

Parts Used:

Shield

Wayne from LAKEVILLE, MA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Wrench set

1 person found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Right axle bent

Replacing belt with no problem. I've ordered the front right axle spindle assembly three times. This is from your parts list and you sent me the part and they did not work at all.

Parts Used:

Belt Drive 54

MATTHEW from PENNSBURG, PA
Difficulty Level:
Very Difficult
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers, Wrench (Adjustable)

1 person found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Deflector shield cracked. Need to replace.

Mark the location of the spring so you know how it goes on. Snip off the push nut holding the deflector shield pin. Hammer the pin out. Insert the pin with the spring holding the new deflector shield. Use a socket to steady the push nut and hammer the pin into the push net until secure.

Parts Used: