JFD2589KES Jenn-Air Refrigerator - Instructions

Sorry for delay in writing. Part I ordered arrived two days ago and it was exactly what I needed. Knowing that there will be problems even with the smallest job I procrastinated starting. When I did start this morning I foud I had to completely remove the ice maker and disassemble it in order to install the water fill cup bracket. The challenge was reassembling the unit. Not hard for an experienced repairman but a challenge for layman. Everything is thing is back to gether now and power on cooling down the refrigerator. Won't know how successful it was until turn on water and ice is formed. If it works this saved $75 just to get a Sears repairman to come out and tell me what would be needed to fix the refrigerator and $1,000 if I had to buy a new refrigerator. Extremely satisfied with service I received. Thank you.

I fortunately found the Part Select web site!! Used the trouble shooting guides and diagrams to diagnose the likely problem. Viewed the installation videos provided on the site and followed the procedure to complete the repair in about 15 minutes. It was a snap (actually three snaps) Fridge now working like new!! Thanks for the great information, guidance, pricing and superfast delivery!! Ron

removed drawers and glass; removed screws from end cap. removed screws from metal drawer runner. popped end cap off. reinstalled new end cap; attached metal drawer runner; cleaned everything and put glass back in as well as drawers. sweet

Thought I needed a new filter. Did not solve the problem. I returned the filter to partselect as per instructions. Will order from partselect when I need parts.

Lift drawer off sliders. Remove two screws holding drawer slider. Remove two screws holding left side pantry end cap. Screw new end cap into place. Screw draw slide into place. Replace drawer. It was a quick repair and finding the replacement part was real easy since the right side end cap needed replacing last year for the same problem. Weak design, but that's another story.

The repair was easy! I was so impressed with the speed of the delivery of the parts I ordered! I only paid for regular delivery and I had the parts in less than a day. You are awesome!!Thank you!

I lost the instructions so took one piece at a time off and put it on the new part. Then mounted it in the refrigrator. Works better than when it was new. Thanks for very quick shipping.

Very easy as described by everyone else here. One tricky part slowed me down a bit. When you try to remove the End Cap after removing the screws you find that it is connected to the climate control bar on the rear part of the fridge cabinet. There is no screw connection, just a tab on the end of the piece, near the center of the cabinet. Just pull the End Cap away from the side, pivoting the entire unit toward the center of the fridge. This will allow the tab to slide out of the opening in the back.

Easy...

Remove two hanging drawers (fruit and vegetable). Remove top glass and two supports for the chef's pantry. Removed chef's pantry. Remove three large screws from the pantry end cap (front, middle and rear). The end cap can now be removed. NOTE: The pantry drawer slide will still be attached to the end cap. Once the end cap is removed detach the rail by removing two smaller screws. TIP: Use either a nut driver or socket verses a screw driver it works out better. At this point replace the end cap and install in reverse of removal.

The vertical mullion rail had detached from the plastic panel which was secured to the door of the refrigerator. Three wires were exposed. Plastic panel removed (with the exposed wires), new panel (already attached to the new mullion rail) had wires enclosed in plastic, which were then plugged into a corresponding plug on the refrigerator door. Slide the mullion rail on the plastic hinges (one on top and one on bottom). Tighten the bolt on the plastic panel, and voila! A 5 minute job for this 60 year old female.

Received the grille and placed it in it's place. Not difficult at all.

It was very simple. Took off the bottom glass, took out the drawers-veggie and meat, took out deli drawer. Removed old end cap and the rail guide. Put rail guide on new end cap and replaced back into spot. Repeat on other side. Replaced drawers and shelf.

Read as many of the comments on this website as I could. Practiced before the part actually came. Everything fit just according to plan. Hope "I don't know" doesn't return anytime soon.

Ordered part on PartSelect.com. Easy to find part from charts. Part deliverd quickly. Total time to install was 1/2 hour. 25 minutes of that time was cleaning the inside of the refrigerater while I took apart the pieces required to install the pantry side. Very easy...Only tools required was a nut driver and phillips screwdriver....30 minutes