GSM1800F02BB General Electric Dishwasher - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
cap was melted
-
Greg from Doon, IA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
16 of 17 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
soap dispenser latch was worn - cover would not stay shut
remove door panel (outer side) remove wires from soap dispenser remove old dispenser install new dispenser re-install wires and door cover total time less than 30 minutes
Parts Used:
-
Dean from Newark, NY
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
11 of 16 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Silverware basket had holes in it.
Took old one out and replaced new one in less than one minute.
Very easy and easy to order also.
Very easy and easy to order also.
Parts Used:
-
Pauline from Oceanside, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
6 of 8 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Lost Rinse Aid cap
-
Jerome from Arlington, VA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
7 of 14 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dispenser Cap Missing
-
Larry from Denvr, CO
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
3 of 4 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Bottom of basket deteriorated
Remove old basket, discard, place new basket in dishwasher, fill with dirty silverware, run wash cycle.
Parts Used:
-
George from Gregory, MI
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
3 of 4 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dishwasher didn't clean well. Silverware basket was damaged.
Just removed the old ring nut by hand and replaced it with the new one. Took me one minute.
Exchanged the silverware basket.
Exchanged the silverware basket.
Parts Used:
-
Andre from Ventura, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
3 of 5 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
cap had melted mi
-
Alice from BLAINE, MN
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
2 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
top washer arm performing poorly
removed top rack which contains washer arm.
unscrewed the old ringnut which had lost its gasket, that the top rack washer arm merges with.
screwed the new ring nut onto the threads of the pipe which protrudes thru the back inside if the machine. reinstalled the top rack .
job done.
unscrewed the old ringnut which had lost its gasket, that the top rack washer arm merges with.
screwed the new ring nut onto the threads of the pipe which protrudes thru the back inside if the machine. reinstalled the top rack .
job done.
Parts Used:
-
Duane from Springfield, MO
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
3 of 5 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
missing cap
-
Jean from White Plains, NY
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
3 of 5 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Leaking from top of main conduit
Note: I also purchased the main conduit part (PartSelect #: PS958967).
My repair is pretty much the same as the previous poster from TX. The RING NUT W/GASKET part seems to wear easily on this GE dishwasher.
Disconnected dishwasher from electrical. You have to remove the rear lower brace panel in order to remove the main conduit. The bottom end of the main conduit is clamped to a hose.
Installed the new main conduit and o-ring, screwed RING NUT W/GASKET onto upper end of main conduit. I tightened the ring nut with the wrench to make sure I got a good seal without over tightening.
I had to use a new hose clamp to reattach the lower end of the main conduit.
Reinstalled brace panel, reconnected electric, and tested.
It was an easy fix, the parts did not cost too much. I'm glad I fixed it rather than paying some repairman $$. I purchased an extra RING NUT W/GASKET in case it deteriorates again.
My repair is pretty much the same as the previous poster from TX. The RING NUT W/GASKET part seems to wear easily on this GE dishwasher.
Disconnected dishwasher from electrical. You have to remove the rear lower brace panel in order to remove the main conduit. The bottom end of the main conduit is clamped to a hose.
Installed the new main conduit and o-ring, screwed RING NUT W/GASKET onto upper end of main conduit. I tightened the ring nut with the wrench to make sure I got a good seal without over tightening.
I had to use a new hose clamp to reattach the lower end of the main conduit.
Reinstalled brace panel, reconnected electric, and tested.
It was an easy fix, the parts did not cost too much. I'm glad I fixed it rather than paying some repairman $$. I purchased an extra RING NUT W/GASKET in case it deteriorates again.
Parts Used:
-
Tom from Brooklyn, NY
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers, Wrench (Adjustable)
2 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
holes in dishwasher silverware basket
-
Deborah from Los Osos, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
2 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Water Leak
Replaced main conduit, o ring,and ring nut with gasket.
Parts Used:
-
ANDY from SHELBY, OH
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Pliers, Screw drivers, Wrench set
3 of 6 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
door gasket bad, door deformed
removed inner panel, removed soap dispenser installtion was straight forward 45 min time install
Parts Used:
-
john from TORONTO, OH
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Screw drivers, Wrench set
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The basket handle was broken in transit.
I ordered the silverware basket because the original started to separate. The shipment box was damaged and sure enough the handle was broken. The handle can be removed so I replaced the new handle with the old handle, since it was the basket that really needed. Pops off very easily.
Parts Used:
-
John from ANN ARBOR, MI
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!