This is the replacement water valve for your washer. It has 2 inlets and 3 outlets. The water valve connects to the water source and solenoid wires, and ensures the tub has the right amount of water e...
Ask our experts a question about this model and we'll get back to you as soon as possible!
4 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Yusbeidys
January 26, 2020
The washer starts to fill and drains the water without filling
For model number GFWN1100H0WW
Hi Yusbeidys, thank you for your question. If you are not getting any water into your appliance. You may have to replace your water filter. Good luck with your repair.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Graham
February 17, 2022
Filter has been cleaned
110 power has been checked. ok
On off power does not light
For model number GFWN1100H0WW
Hello Graham, thank you for writing. Based on our research, we have found the part you are looking for is the Water Valve with 2 Inlets and 3 Outlets PartSelect Number PS1482392. We have an installation video for you to access. We hope to hear from you soon.
Hi Anders, thank you for reaching out. We would suggest checking the start button for any damage first. If it is fine, the issue could be with the user interface board, part number PS11721797. It processes the cycle settings you choose. You may need to replace it to fix the issue. We hope that helps!
In the washing cycle, it ends, but the water does not drain and the display shows "pause" and you hear the motor, but the water does not drain.
For model number GFWN1100H0WW
Hi Fernando, thank you for contacting us. We would suggest checking the drain hose for clogging first. If it is fine, the issue could be with the drain pump, part number PS16743374. It removes water from the washer during the drain portion of the cycle. You may need to replace it to fix the issue. We hope this solves your problem!
I called a repair person to check my 15 months old GE front loader washer that stopped in rinse mode. After his inspection he said it was a deffected computer board and it would be very expensive to replace the 3 computers boards inside and it would be cheaper to buy a new top loader washer. The next day I lifted the top cover and foun
... Read mored a taped plastic envelope with instructions titled “For service Technicians Only." On page 2, instruction on to how to enter the washer in to service mode and to test the washer: Press : Signal, Delay, Signal, Delay (within 30 seconds of plug in washer) Then rotate main knob to #102 and press Start:(the washer did a test for finding the problem) , and for me was : E22 , it means : replace solenoid valve assembly. So I order the part from Partselect.com for $58.00 and my Washer runs beautiful, thanks to the instructions inside.
Removed three 7mm sheet metal screws from the bottom front panel. The drain pump is in the front right. Removed the manual drain screen to drain residual water from the system. A bucket was necessary to collect all the water. Disconnected the inlet and outlet hose. Disconnected the electric supply. Removed two Phi
... Read morellips screws holding the pump to the bottom of the machine. Slid the pump towards the rear to clear the support pegs and removed it from the front opening. Installation is the reverse of those steps.
