Models > ERD30 > Instructions

ERD30 Dacor Range - Instructions

All Instructions for the ERD30
1 - 3 of 3
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Temp sensor is failing
I did not do the repair since the part shipped was not the correct one. I have contacted Customer Service by phone and mail and nothing has been resolved.

I would, at least, like to return the incorrect part. An new one would be great but not holding out hope.
Parts Used:
SVC-TEMP SENSOR KIT ROBERTSH;86663,ERSD3
  • Sarah from FORT COLLINS, CO
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
3 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dacor sent a different bulb # which I CANNOT get back into the oven.
I have contacted Dacor repeatedly with no response, by both phone and left my return contact and email.
I could not be more disappointed in Dacor. All this for a problem which is listed as a home maintenance issue. A light bulb for $41.77 that I cannot install.
Parts Used:
SVC-HALOGEN BULB 10W 12VAC;86573,ERD36S0
  • Marilyn from INDIAN WELLS, CA
  • Difficulty Level:
    Very Difficult
  • Total Repair Time:
    More than 2 hours
  • Tools:
    Screw drivers
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Flame was not even all around.
Cleaned the brass ring and replaced the cap.
New brass rings may be an improvement too.
Parts Used:
SVC-DBURNER CAP LARGE;72435SB,DTCT304GB/
  • Keith from MIAMI, FL
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the ERD30
1 - 3 of 3