DRT900 Husqvarna - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Spring on clutch cable broke
Remove L. wheel.
Remove guard shield.
Remove old cable.
Install new cable.
Adjust throw on cable.
Put all parts back and test
Remove guard shield.
Remove old cable.
Install new cable.
Adjust throw on cable.
Put all parts back and test
Parts Used:
-
David from SKANDIA, MI
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Screw drivers, Wrench set
2 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
replaced old belt
-
David from WINSTON SALEM, NC
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Socket set, Wrench set
4 of 9 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Right axle bent
Replacing belt with no problem. I've ordered the front right axle spindle assembly three times. This is from your parts list and you sent me the part and they did not work at all.
Parts Used:
-
MATTHEW from PENNSBURG, PA
-
Difficulty Level:Very Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Screw drivers, Wrench (Adjustable)
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
broken drive axle chain
removed engine, sheet metal, handle bars, and tines. Seperated transmission case and replaced broken chain. This is not difficult it's just time consuming. A tiller repair shop would charge about $400 to do this job. It cost me $40 for a chain and gasket, Both fit perfectly, great service. Thanks
Parts Used:
-
richard from MECHANICSVLLE, VA
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
1 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Deflector shield cracked. Need to replace.
Mark the location of the spring so you know how it goes on. Snip off the push nut holding the deflector shield pin. Hammer the pin out. Insert the pin with the spring holding the new deflector shield. Use a socket to steady the push nut and hammer the pin into the push net until secure.
Parts Used:
-
Travis from PLATTE CITY, MO
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Socket set
2 of 6 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
part not same
Ordered on/off switch. My switch had only one wire terminal. Replacement had two. I ran a wire from one to a screw as a ground. Switch worked fine.
Parts Used:
-
Bruce from ALGOMA, WI
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
2 of 8 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!