The Dryer's Lint Filter is used to collect lint during the dryer cycle as it passes through the dryer vent, in order to prevent damage to the machine. This manufacturer-approved part comes in gray, me...
This plastic adjustable dryer leg is used to support the weight and adjust the height of your dryer to keep it level. To install the leg, tip the dryer back and screw it into the bottom of your dryer ...
This door seal is a genuine replacement part for LG dryers. It is a gray, rubber seal that fits around the the opening of the dryer door. It is responsible for creating an airtight seal when the dryer...
This dryer side vent kit lets you vent the exhaust to the side or bottom of your dryer instead of the default rear position. Included in the kit are 2 straight aluminum foil outlet ducts, each 4 inche...
This grey drying rack fits inside your front load dryer. It is an accessory used to dry items that should not tumble, like shoes, stuffed animals, pillows, or other delicate items. It provides a stati...
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
2 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Mario
February 22, 2020
Wont stop spinning even with power off unless i open the door. I tried unplugging it resetting it for 5 seconds and still nothing
For model number DLEX3250V
Hello Mario,
Thank you for your question We have done an investigation into your model DLEX3250V, we have discovered that the Door Switch would be the most accurate cause of your symptoms. It is available under part number PS3529308. If the door switch is malfunctioning, it can cause the appliance to continuously run. This is well known the main cause of this issue. If you would like to place an order for the Door Switch, please call the toll free number at the top of the website page. A customer service representative will happily assist you in placing your order.
Ours is dead, light works when door opened. Switch was bad replaced with new. I need help checking main power supply board. You have some voltage checks or tips? Thank you.
For model number DLEX3250V
Hello Mark, Thank you for the question. You would test to see if there is 120 Vac going to and from the Board. We hope this helps!
I bought the whole dryer filter kit, but turns out I only needed the dryer filter and am very happy about that. No tools necessary I just slid it right in. It fit perfectly and I no longer have anxiety about my clothes coming out ripped.
After replacing the locker assembly (female) on the machine, The door strike(male) was hitting well below the locker. I realized that the screws holding the door hinge were loose. Tightening them brought the strike up far enough to engage the locker, although it still hits a bit low. That might have been the real problem, not the latch, s
... Read moreo check the hinge before you order the latch parts.