Models
>
954223470
954223470 Husqvarna Lawn Mower - Overview
Models starting with 954223470
Click on the best match to narrow your results.
Keep searches simple, eg. "belt" or "pump".
Cover, Dust, Wheel
PartSelect #: PS9982436
Manufacturer #: 581840401
The Dust Shield is a 6-3/4 inch, black plastic part, used to prevent dust or debris fouling the wheel or axle. It attaches inside of the wheel around the axle. Installation is rated as "Easy" and will...
$4.99
In Stock
Bolt, Handle
PartSelect #: PS9014802
Manufacturer #: 532191574
This Handle Bolt is sourced directly from the original equipment manufacturer for use in various lawn and garden equipment. It is used to secure the upper and lower handles together and is tightened b...
$3.99
In Stock
Engine Zone Control Cable
PartSelect #: PS9015022
Manufacturer #: 532183567
This zone control cable is for lawn mowers.
Zone control cable stops the engine when you let go of the handle.
$14.93
In Stock
Nut Lock 5/16-18
PartSelect #: PS9160134
Manufacturer #: 873800500
Nut lock 5/16-18 (5/1 Lock nut) is a 5/1-18 inch silver metal nut. It can be installed using a wrench or socket to secure parts in pace, and to lock down to prevent backing out due to vibration. If da...
No Longer Available
E-Ring 7/16
PartSelect #: PS9145393
Manufacturer #: 812000058
The E-Ring 7/16 is a 7/16-inch silver, metal part which can be attached to various locations on a variety of equipment to snap into grooves and secure parts into place. This part will require pliers t...
$3.99
In Stock
Nut, Hex, Flangelock
PartSelect #: PS9022497
Manufacturer #: 532409149
Made of high-quality metal, this hex flange locknut is designed for use with various lawn mowers and ride-on mower/tractor models and is sold individually. This locknut attaches to the end of the carr...
$4.99
In Stock
Hardened Washer
PartSelect #: PS9019116
Manufacturer #: 532851074
This washer is not part of a kit or assembly. It is sold individually. With an O.D. of 1 inch, this OEM replacement part is made of dark grey metal and is used to provide a tight seal between the mowe...
$4.99
In Stock
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Cable was broke.
Pushed the cable through the engine mount.Connected the cable to the engine slider. Pulled cable through the previous tie down connected to the lower end of the bar. Attached the connector on the cable to the hole in the lawn mower bar near the top of the bar.. Attached the top end of the cable to the on/off bar where you push the mower.
Parts Used:
-
James from ASHTABULA, OH
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers
6 of 6 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!