7GU3600XTSY1 Whirlpool Dishwasher - Instructions

Due to the posts on this site, I took the advise of replacing the chopper assy. Old chopper did not look bad and seemed to function. Apparently I was wrong. After new chopper was installed, dishwasher worked fine.

put new on and tightened correctly -was nice to get the right part the 1st time !

Slid the dishwasher out, removed the old hinge and replaced it with the upgraded kit. Appliance repairman wanted $168.00 to do the job and I repaired it for $30.00. Thanks for the great service

I look at the video you put up to help. The part was replace and my dish washer works really well now. I will use this site again and well tell my friends also. Thank You for all your help . Mark

Actually your video lays it out very well. Went exactly as it shows and was very easy. I did not have to pull it out to the point I had to disconnect any water or electrical connections. Worked great! Replaced both sides as the new rollers turn and the old ones did not causing a horrible squeak when the door was opened or closed. Now, no noise at all.

1)remove 6 torx [T15] screws holding dishwasher front panel 2)use screwdriver blade to release electrical connector plug 3)remove 8 hex-bolts [1/4"] holding dispenser retainer plate 4)while holding-up flexible plastic covering dispenser unit 5)use screwdriver blade to "push-up" metal retaining tabs to 6)release soap dispenser unit, remove old & replace with new 7)re-install dispenser retainer plate, install 8 hex-bolts 8)make sure to tighten bolts equally to prevent misalignment 9)carefully snap electrical connector plug in-place 10)finally -> replace front panel & tighten 6 torx screws 11)hardest part of project was making up my mind to start

I'm a 74 yr old women and have always tried to do my own repairs. With the web it was so easy to locate the problem and order the part. The online repair demo video was so easy to follow. Really proud of myself. "I still got it".

Had to find the leak first, which was a big process. Once found, it was a matter of removing the part, looking it up om partselect.com , ordering it and reinstalling which wasn't too difficult. The installation took about 45 minutes. I was psyched to find a website that could simplify this repair without calling a mechanic or plumber!

Watched the repair video on the internet link which made the repair very easy to understand.

looked up replacement item on net[ your page], ordered and installed...exact part, priced right and shipped on time....good experience....v