7GU2300XTVS0 Whirlpool Dishwasher - Instructions

1)remove 6 torx [T15] screws holding dishwasher front panel 2)use screwdriver blade to release electrical connector plug 3)remove 8 hex-bolts [1/4"] holding dispenser retainer plate 4)while holding-up flexible plastic covering dispenser unit 5)use screwdriver blade to "push-up" metal retaining tabs to 6)release soap dispenser unit, remove old & replace with new 7)re-install dispenser retainer plate, install 8 hex-bolts 8)make sure to tighten bolts equally to prevent misalignment 9)carefully snap electrical connector plug in-place 10)finally -> replace front panel & tighten 6 torx screws 11)hardest part of project was making up my mind to start

Removal and replacement of the gasket required no tools and took very little time. However, this did not solve the problem. I called in a repairman who determined the issue was the washer was not filling to the proper level. The control board was replaced and the problem was solved. This also quieted the washer a lot in that the pump was no longer sucking air.

Had to find the leak first, which was a big process. Once found, it was a matter of removing the part, looking it up om partselect.com , ordering it and reinstalling which wasn't too difficult. The installation took about 45 minutes. I was psyched to find a website that could simplify this repair without calling a mechanic or plumber!

looked up replacement item on net[ your page], ordered and installed...exact part, priced right and shipped on time....good experience....v