Models > 66561619100 > Instructions

66561619100 Kenmore Microwave - Instructions

All Instructions for the 66561619100
211 - 215 of 215
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Replace charcoal filters in microwave - vents inside.
Remove the screws holding the bottom vent plate to the upper unit, using a Phillips head screwdriver. Loosen a front screw last, but don't remove it. While supporting the plate in one hand, unscrew the final screw with the other. Lower the front of the bottom plate - tabs in the rear will prevent the plate from falling out. Bend the outer tabs holding the old filters in place, to allow them to be slid out. Insert the new filters & bend the tabs back into locking position. Raise the bottom plate and finger tighten a front screw. Replace and tighten all screws. This is also a simple way to remove/clean/replace the mesh filters. I've pulled the D-rings off trying to slide them out from below.
Parts Used:
Charcoal Air Filters
  • Randall from Washington, IL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
mounting points for grill broke off
old grill was already off. I snapped in the new grill and inserted the mounting screws. tha was it. it fit perfect.
Parts Used:
Vent Grille
  • ALLEN L from DRAVOSBURG, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
replacement of filters
just replaced the filters
Parts Used:
Grease Filter Charcoal Air Filters
  • THEODOROS from VIRGINIA BEACH, VA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
The small connector flaps broke off so the grille wasn't attached.
With a phillips head screwdriver I removed the screws, which were screwed to the then non-existent grille, at the top of the grille holder, GENTLY popped the new grill into place and replaced the screws. It took about five minutes. As a housewife, I feel that doing these little repair jobs around the house saves my husband time and aggravation. It was all very simple, and I got the ordered part in two days. Fabulous!
Parts Used:
Vent Grille
  • Clarissa from Fallston, MD
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Burn't out bulb.
Removed the glass cover and replaced the bulb. Very simple.
Parts Used:
Light Bulb - 40W
  • Carter from McCordsville, IN
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the 66561619100
211 - 215 of 215