This Ni Nut-Lock, or Nylock Nut, is a Silver 1/4 x 20 metal nut. Sold individually, it can be adjusted using a wrench or socket and torque wrench to the manufacturer specfications, and is used to secu...
The manufacturer-approved Ratchet Pawl (Starter Pawl) comes in a set of two (2). This part attaches inside the recoil assembly, and is used to engage the flywheel. if broken due to wear/damage it will...
This needle and seat kit, also known as a float valve, is found in many types of liquid-fueled lawn equipment, such as carburetors. The valve regulates the flow of fuel into the float bowl. The needle...
This is a replacement fuel tank for your outdoor power equipment. It is made of black plastic and comes with the tank itself, as well as the fuel cap. The fuel tank stores fuel before it is transporte...
This OEM Oil Seal is an individually sold rubber part which is attached around the axis shaft on the crankcase housing to provide a proper seal. A broken seal will lead to a leak, and the part should ...
A washer is used for things such as load distribution, stability, alignment and protection for whatever equipment it is fastened between. This curved washer, also known as a wave washer or spring wash...
Removed tank and drained old gas. Removed and disassembled carb. Needed new gaskets and seals, and had to clean corn syrup glaze (separated ethanol) from bowl and everywhere else with carb cleaner. Throttle linkage was de-plating/rusty. Steel wool and WD40 got it moving again. Cleaned spark plug electrode. Reassemble
... Read mored, poured Sea Foam in the bottom of the tank and gave it a few pulls. Let Sea Foam sit for a while, then filled the tank with Premium. Blew white smoke for a minute then ran like new. Shredded for a while, then changed the oil.
Remove the spark suppresser, 4 face screws, 2 bottom screws and the two screws the hold the gasket. I also had to back out the top screw of the cover it blocked and prevented the removal of the gasket.