Models > 28600 > Instructions

28600 Weed Eater Lawn Mower - Instructions

All Instructions for the 28600
1 - 3 of 3
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Take the wheel off. Place the key in the slot. Put the wheel back on.
Just described it.
Parts Used:
Key
  • Gary from PILESGROVE, NJ
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
4 of 8 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Lound deck noise when mower put into motion
Parked mower on level concrete drive, laid on cardboard. Lowered mower deck all the way. Sparayed some WD40 on nut/bolt on top of old pulley. Since it is a carriage type bolt, placed 5/8" boxed end wrench over self locking nut on top of old pulley. Using some force from 3lb mallet to break nut free (hitting against wrench body), the nut came off easy as did broken pulley/bearing inside. Installed new pulley assembly, re-tightened nut on bolt. Checked after first mowing just to be certain pulley was in place and locking nut tight.
Parts Used:
Pulley
  • Steven from Hickory, NC
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Socket set, Wrench set
4 of 12 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Front wheels, too much end play
Shimmed the wheels out on axle.. No more slop.
Parts Used:
Washer 25/32 x 1-1/4 x 16 Ga.
  • Frederick from BINGHAMTON, NY
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
7 of 28 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the 28600
1 - 3 of 3
Back to Top