25368823010 Kenmore Refrigerator - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
evaporator coil kept freezing up, refridgerator warm.
This was the second part I tried. The defrost timer was first, but that did not fix it. To do this I had to remove the ice maker and the back plate of the freezer. Then I defrosted the coil and cut the wires. stripped them back and installed the new thermostat. re-assembled and tested. has been working great ever since.
Parts Used:
-
Greg from Hanover Township, PA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Pliers, Screw drivers
182 of 200 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Refrigerator would not run but interior light was on.
I unplugged the refrigerator, then opened the door and removed four screws holding the plastic electrical panel to the interior top of the main refrigerator compartment and noticed the cold control was corroded badly, apparently from moisture in the panel. I ordered a new one from partselect.com. When it arrived the next day, I then pulled off the control knob, unclipped the cold control, unplugged the three wires to the control, then removed the styrofoam insulation blocks holding the thermocouple wire and then removed the thermocouple wire to complete the removal. I then reversed the process to install the new thermostat and control. That is repositioned the thermocouple wire, put the insulation blocks back to hold the wire, then replugged the three electrical wires, clipped the control back and pushed the control knob back on and finally screwed the panel back to the top of the main compartment and plugged the refrigerator electrical cord back in to provide current to the refrigerator. It immediately started up and ran fine. Total time - about 8 minutes.
Parts Used:
-
Bruce from Alton, IL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Pliers, Screw drivers
179 of 232 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Refrigerator door gasket was torn at bottom.
The gasket pops into a channel could not have been easier.
Parts Used:
-
Les from Fenton, MO
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
59 of 75 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Light socket melted around bulb
After unsuccessfully trying to change the blown light bulb I discovered that the plastic light socket had gotten so hot that it melted and permanently fused with the blown bulb. After my new socket arrived in the mail I just popped the temp control assembly out with a screw driver and removed the old socket and placed the new one in. Whole operation to 5 minutes.
Parts Used:
-
William from Alexandria, VA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
65 of 107 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The door shelf/bin broke and fell off
I simply snapped in the new part. It took a few seconds. I would like to say that I found the part using the model number of the fridge. When I went to look at the description it said the part was 26 inches. The one I had was only 24 3/4 inches. I called you guys and was told that this was the correct part and to ignore the measuement.
You were Right! the part fitted perfectly.
You were Right! the part fitted perfectly.
Parts Used:
-
Phillip from Cary, NC
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
45 of 50 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The Crisper Drawer Glass Shelf slid out of the frame while being cleaned and shattered.
The repair didn't require any tools at all. Just simply slide the new glass shelf carefully into the the frame and while holding it horizontally slide the frame back into the rails. This took less than a minute to accomplish. Very satisfied with the results.
Parts Used:
-
Ernesto from Porter, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
42 of 52 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Old gasket needed replacing
This was a really easy replacement job, but it did not have any directions. The main thing to know is to really "warm" up the new gasket before installing so that it can easily be fit into the door of the refrigerator. Some recommend putting it in warm water, but it's pretty big & I didn't have anything to put it in, so I used a hairdryer to soften it up. It also takes a few days for it to "form" to the door. When I received it, the top right had a seem split, not an actual "rip" but it looked like the glue did not stay to connect the edges very well. I called and Part Select issued a refund and got a new one out to me the next day! Great company!
Parts Used:
-
Vimpun Jay from Charlottesville, VA
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
37 of 44 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Glass shattered
Don't ever tell your 11 year old to clean the refridgerator. Something will almost definetly get broken like the glass shelf, but luckily I had parts select which in no time assisted me to find the exact part. I ordered the part, it came quickly and I replaced within seconds.
Thanks.
Thanks.
Parts Used:
-
Adona from Gretna, LA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
28 of 33 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
broken and cracked bins
Replaced the old bins with the new bins...The most important part of the story was finding this website and locating and ordering the necessary components...that was amazing - a few clicks of the mouse and my new parts were on their way.
Parts Used:
-
Ruth from Livonia, MI
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
30 of 39 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
No freezer shelf came with our new refrigerator.
No long shelf came with our new refrigerator, Frigdaire did not have one so I went on-line from you and it fit perfectly, now everything does not have to be in one big heap.
Parts Used:
-
TRACY from MAPLE GROVE, MN
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
19 of 23 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
plastic hook broke
-
Christina from Tacoma, WA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
16 of 19 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
cracked bottom hinge
My 4 year old grandson used the frig door as a swing.The bottom hinge cracked, then the door wouldn't seal. I propped the door up with some books, removed the broken hinge (2 bolts) and replaced with the new part. Simple fix on the door, only time will fix the 4 year old!
Parts Used:
-
LEE from LEO, IN
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Socket set
14 of 18 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Bottom shelf on door cracked and broke
I ordered the Door Shelf Bin from PartSelect.com on Friday and received it on Saturday!! I was shocked, but thrilled. The easy to use diagram helped me to pick the right part and I easily replaced the broken one. I have already started to recommend PartSelect.com I was so thrilled with their service!
Parts Used:
-
Jamie from Greensburg, PA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
12 of 14 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
No shelf in Freezer compartment though obvious slots provided.
Used model # of frigidaire on your web site... reviewed parts available... noticed shelves abailable... zoomed in to measure using crosshatch background... measured my freezer compartment... seemed doable... ordered shelf... receivednext day... attempted to slip in slots... had to grind off 3/16th inch on two legs... slipped in... Perfect!
Parts Used:
-
Joe from Dallas, TX
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
10 of 11 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
FREEZER WAS COLD FRIDGE WARM
YOU TUBE VIDEO POINTED ME IN THE RIGHT DIRECTION. USED MULTI METER TO CHECK FOR VOLTAGE. NONE, REPLACED DEFROST HEATER. WORKS LIKE A CHARM, PART DELIVERED TO MY DOOR FOR LESS THAN $60.00, IN TWO DAYS FROM PARTSELECT. FIXED IT MYSELF FOR LESS THAN THE COST OF A SERVICE CALL.
Parts Used:
-
JEFF from OLIVET, MI
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers
10 of 12 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!