Models
>
21A-664D766
21A-664D766 Troy-Bilt Tiller - Overview
Models starting with 21A-664D766
Click on the best match to narrow your results.
- 21A-664D766 ( 2005 ) Troy-Bilt Tiller (Troy-Bilt Tiller Model 21A-664D766/2005 (21A664D766/2005, 21A 664D766/2005) Parts)
- 21A-664D766 ( 2004 ) Troy-Bilt Tiller (Troy-Bilt Tiller Model 21A-664D766/2004 (21A664D766/2004, 21A 664D766/2004) Parts)
- 21A-664D7667HP ( 2004 ) Troy-Bilt Tiller (21a-664d766 7hp Roto-Tiller (2004))
Keep searches simple, eg. "belt" or "pump".
Oil Seal-Wheel Shaft
PartSelect #: PS10027983
Manufacturer #: 921-04031
This OEM Wheel Shaft Oil Seal is a black rubber part which attaches to the drive shaft to prevent leaks between the wheel shaft and transmission case. Installation is rated as "Medium" difficulty and ...
$10.48
In Stock
Washer-Lock 5/16
PartSelect #: PS9311087
Manufacturer #: 936-0119
This Washer-Lock 5/16 is a silver, metal part that is sold individually and comes direct from the manufacturer. With a 5/16 Inch Interior Diameter and 1/2 Inch Outside Diameter, it is used to prevent ...
$4.99
In Stock
Forward Idler Pulley
PartSelect #: PS9457633
Manufacturer #: 756-04170
This OEM Forward Idler Pulley attaches to the pivot bracket to allow the forward belt to idle when not in forward motion. If broken, the machine will no longer be able to propel forward, and the part ...
No Longer Available
Keyed Washer 1.0 X 0.38 X 0.37
PartSelect #: PS9455313
Manufacturer #: 736-04445
No Longer Available
Battery 245 CCA Dry
PartSelect #: PS9310460
Manufacturer #: 925-1707D
NOTE: Battery is not charged and does not include electrolyte or acid.
No Longer Available
Ignition Switch: 5 Pin
PartSelect #: PS9310387
Manufacturer #: 925-0267B
This OEM 5 Pin ignition Switch is a silver, steel, individually sold part. It can be installed using a wrench and screwdriver, and has been rated as Easy to install. The part attaches to the dashboard...
$36.40
In Stock
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Bearing seized
Pull belt cover, 2 nuts
Remove tensioner, 1 nut
Slide old tensioner off and replace
Remove tensioner, 1 nut
Slide old tensioner off and replace
Parts Used:
-
Gary from ELGIN, OK
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Socket set
2 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
1inch shaft and wheels have to be removed first.
Wheels had to be cut off of the axle in order to get to the seals. The center of wheel is 3in wide and axle isn't tappered on troy bilt pony model wheels where rusted on.
Parts Used:
-
Norman from RAINIER, WA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:1- 2 hours
-
Tools:Pliers, Socket set, Wrench set
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!