The Stepped Washer is used to secure the wheels onto the shaft of a push mower. It attaches to the wheel axle. If broken due to wear/fatigue, the wheel will come off and the part should be replaced. I...
This is a genuine OEM replacement blade for use on Lawn Mowers. If the blade is too dull it will tear the grass instead of an even cut. A bent or damaged blade can cause serious damage or injuries. Yo...
This cable-traction is sourced directly from the original equipment manufacturer. It is specially designed for use with Toro lawn mowers. The traction cable engages drive wheels on the equipment. Over...
The Shoulder Bolt is a 3/8-16 x 3-5/8 bolt, certified by the original equipment manufacturer. It is a metal bolt which is individually sold and comes in black. Installation requires a wrench or socket...
This is a genuine replacement v-belt sourced from original manufacturer and it is used on Toro lawn mowers. This part is made out of rubber and it is sold individually. This is the the belt that is at...
Tip mower onto side, raising side to be repaired. Empty gas tank if possible or use rags to prevent gasoline drips onto clean surfaces.
Remove wheel using a 1/2" socket. Remove wheel height assembly with 1/2" socket and open end wrench to hold nut below the deck. Position new spring arm over the slot on wheel height
... Read more assembly plate. Check opposite side to verify correct orientation if needed. Remove plastic cover from old lever using a small flat blade screwdriver. Slip onto new lever. Replace wheel height assembly. Replace wheel.