Enter the code DIYDAD10 at checkout to apply your discount. Discount will be applied at checkout when the code is entered & applies to all parts. Cannot be combined with any other coupon or special offer & cannot be applied to a previously placed order. Not valid toward tax or shipping & handling. Discount has no cash value. Discount expires on June 17 at 11:59pm EST.
You've Got 10% Off Your First Order!Save 10% with code at checkout *click to copy coupon code
This OEM Oil Seal is an individually sold rubber part which is attached around the axis shaft on the crankcase housing to provide a proper seal. A broken seal will lead to a leak, and the part should ...
The O-Ring is a black rubber part, used to provide a seal between two pieces. It can be used in various locations on a variety of equipment. Installation is rate as "Easy" and will require a screw dri...
This was an OHV motor so in order to get to the head, you must remove the valve cover and remove the push rods. Remove all four head bolts in an even star pattern. Remove the old gasket and scrape all remaining gasket gunk. Put new gasket on and tighten head back on with an even star pattern. Slide push rods back in and adjust valves to .
... Read more004 of an inch and put valve cover back on and start it up!
Remove the top cover and pull cord assembly. Remove the muffler cover. Lift off the gas tank and disconnect from the air filter box. Remove the air filter box and carb from the head cover as a single unit. Remove the head cover. You can leave the valve cover in place. Remove old gasket material. Clean surfaces. Replace gasket. Reassemble
... Read more. *if the valve stems come loose from their seats or rockers, remove the valve cover and reseat. Reassembly is the opposite of disassembly. Happy mowing.