General Electric Dryer Switches

Your Price

$30.86

General Electric Dryer Push-to-start Switch

★★★★★

29 Reviews

PartSelect Number PS3487190

Manufacturer Part Number WE4M416

Restore reliable operation to your GE dryer with this genuine OEM push-to-start switch, designed specifically for use with a range of GE dryer models. This switch activates the dryer when you press and release the button, making it an essential component for proper startup. Common signs that this part may need replacement include the dryer failing to start or starting unexpectedly without pressing the switch. Replacing the switch is a straightforward repair and requires only a Phillips screwdriver and a flathead screwdriver. Before beginning the installation, always disconnect the power to ensure safety. Once the power is off, remove the control panel screws, disconnect the old switch, and install the new one in its place. This part is sold individually and is a reliable solution for restoring your dryer's functionality with minimal effort.

Fixes these symptoms

Timer Not Working
Touchpad does not respond
Will Not Start
See more...

Installation Instructions

Gary from LAVALLETTE, NJ

replaced start button and start switch

disconnect power plug unscrew 3 screws in back. lean forward remove button disconnect 2 wires in back of switch. put switch connect 2 wires and button. connect 3 screws in the back. ready to start working Read more...

Your Price

$17.90

General Electric Dryer Door Switch

★★★★★

27 Reviews

PartSelect Number PS12722948

Manufacturer Part Number WE04X28977

This is the door switch for your dryer. Door switches are used to communicate with the control board when the door is fully closed, so the drying cycle can safely begin, and if it is opened so it can stop. If this door switch is damaged or bad from extended use or excessive force when closing, it will cause your dryer not to start, and it will need to be replaced. This door switch will require a few tools, such as a screwdriver, wrench, and pliers to replace, and some slight disassembly of your dryer. This door switch is an OEM part and is sold individually.

Fixes these symptoms

Door won’t close
Won’t Start
See more...

Installation Instructions

Kenneth from COATESVILLE, PA

Dryer would not start

I popped the door switch out with a small screwdriver, disconnected the electrical connection and re-connected the new switch and popped the new switch in place with a little adjustment. Read more...

Videos!

Your Price

$27.87

General Electric Dryer Rotary Start Switch

★★★★★

63 Reviews

PartSelect Number PS3487203

Manufacturer Part Number WE4M519

This replacement start switch is a genuine OEM part for your dryer. If your dryer will not start or shut off, you may need to replace this part. For this repair you will need a number 2 Phillips screwdriver and a pair of needle nose pliers. Disconnect power to the dryer before beginning this repair.

Fixes these symptoms

Will Not Start
Won’t Start
See more...

Installation Instructions

Mr Dennis from Twinsburg, OH

Knob would not engage, had to manually turn outer ring to start washer.

Used a screw driver and needle nose pliers to remove clip from behind the timer knob. Took 2 minutes to remove clip, i admit it was a little tricky but once you get a grip on the clip very easily removed. Replaced with new knob, old knob gear was completley stripped . put the new clip on and presto, Like brand new.A normal service call would of ran me 45.00 just to tell me what was wrong with the machine. Read more...

Videos!

Your Price

$56.22

General Electric Dryer Rotary Start Switch

★★★★★

23 Reviews

PartSelect Number PS268305

Manufacturer Part Number WE4X881

This part is used to start the dryer once you have selected a setting on the timer.

Fixes these symptoms

Will Not Start
Won’t Start
See more...

Installation Instructions

Jaren from Lemoore, CA

Broken Knob Post

First I unplugged the dryer, then I removed the access panel on the back of the control panel. I removed the wires from the back of the switch...Here is where I messed up. I removed the switch prior to ordering the part, the bad part is the way I removed the part. When you get the new part in you will be able to see how it will be mounted to the control panel. I had no idea, so I did what was necessary to remove it. Needless to say, I bent the hell out of the hole that the switch mounts in. In turn, the installation of the new switch did not go as easily as I would have liked. After straightening out some metal and drowning the thing in epoxy, the new switch is installed. I hooked the wires back up on the back of the switch, plug in the dryer, and dry some clothes. Standing victorious over the dryer with beer in hand, not only did I accomplish the mission but I learned my lesson... destructive removal = BAD! Read more...

Videos!

Your Price

$33.85

General Electric Dryer Interlock Switch

★★★★★

18 Reviews

PartSelect Number PS1481922

Manufacturer Part Number WD21X10261

The interlock switch may also be referred to as a belt switch. This part is a simple on/off mechanism that prohibits the appliance from operating when the door is open. This is a part for your dryer. The interlock switch senses the door is shut and the dryer can begin. This part might need to be replaced if your dryer is not starting or is in process while the door is open. The black rectangular part of the switch is approximately 2 inches long and a 1/2-inch wide with two gold plates on either end. This is a genuine OEM part that is sourced right from the manufacturer.

Fixes these symptoms

Door latch failure
Will Not Start
Won’t Start
See more...

Installation Instructions

Steven from EPHRATA, WA

interlock switch was bad. Prevents the dishwasher form running as it "thinks" the door is still open.

Opened door, removed screw holding down metal plate that presses against interlock switch when door is closed. Removed plastic cover thingy that is over interlock switches. Removed the interlock switch by pressing the plastic lock thingy away from switch. Pulled the wires off each end of the interlock switch. Removed new interlock switch from plastic bag and reversed above procedure. Done, shut door and the dishwasher works. Read more...

Your Price

$17.90

General Electric Dryer Door Switch

PartSelect Number PS16742799

Manufacturer Part Number WE04X34281

Fixes these symptoms

Won’t Start
See more...

Videos!

Your Price

$34.85

General Electric Dryer Door Switch

★★★★★

8 Reviews

PartSelect Number PS2344321

Manufacturer Part Number WE4M415

A door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open.

Fixes these symptoms

Won’t Start
See more...

Installation Instructions

Joshua from Dallas, TX

Dryer would not start

The end repair was very simple and took minimal effort. The time and difficulty was all in the testing. I disassembled the dryer and removed the drum and then hard wired each thermo-fuse to determine where the fault was. After test all of those I was stumped. When I opened the door the light would not come on so I assumed it was a power fault closer to the source. However after all of my testing I couldn't find anything wrong. I then removed the light bulb and realized it was burned out which led me to the door switch being the fault. I removed the switch and soldered the three wire together and the dryer started right up! All I had to do was order a new $15 part, unsolder the wires and plug them in. Would have been so much simpler if that light bulb hadn't of been burned out causing me to over think my diagnosis. This was my first major appliance repair and I did it with only the help of the parts diagram provided on the website. Read more...

Your Price

$44.70

General Electric Dryer Safety Switch Assembly

★★★★★

7 Reviews

PartSelect Number PS16551445

Manufacturer Part Number EBF61496102

Introducing the LG Dryer Safety Switch Assembly, a crucial and authentic product for your LG Dryer. This switch assembly, emphasizing safety, is diligently crafted to prevent your dryer from operating when the door is opened, offering protection and convenience. It's recommended to unplug the dryer before installing and to wear work gloves during the assembly for personal safety against possible hazards. Always confirm the part number is accurate for your specific model prior to ordering as size and shape may vary subtly. This assembly is found in the LG Dryer Parts category, further ensuring its compatibility. A true demonstration of LG's committed provision of quality and precision for your appliance's needs.

Fixes these symptoms

Won’t Start
See more...

Installation Instructions

Phillip H Travers from sioux Falls, SD

Wouldn't shut off

-Remove rear retaining bracket [ (3) screws f/ top lid and (2) screws f/ main chassis]
-Remove top lid by sliding toward rear and lift off.
-Remove front electronics display, (2) screws 1 on both sides.
-Remove main harness plugs from main board
-Remove main board (4) screws
-The reverse to reinstall Read more...

Your Price

$36.85

General Electric Dryer Switch Rotary

PartSelect Number PS11736619

Manufacturer Part Number WE02X25282

The GE SWITCH ROTARY is a crucial component for your dryer, mainly serving as a cycle selector. It allows you to easily choose various cycle settings to meet your drying needs. Ensuring a proper installation is of utmost importance, so ensure to disconnect your dryer from its power source before starting the process. Additionally, wearing protective work gloves is highly encouraged to prevent unwanted mishaps. Choose the GE SWITCH ROTARY to guarantee an excellent performance from your appliance. Trust in the quality and durability of GE products to maintain your dryer's efficiency.