General Electric Dryer Fuses

Videos!

Your Price

$19.30

General Electric Dryer Thermal Fuse

★★★★★

28 Reviews

PartSelect Number PS3530485

Manufacturer Part Number 6931EL3003D

This thermal fuse acts as a high-limit thermostat, and shuts off the heating element when the dryer overheats by cutting off power to the dryer. If the thermal fuse has blown, the dryer will not start. These fuses cannot be reset, so if yours has blown, you will need to replace it. A common reason for the thermal fuse to blow on a dryer is if the exhaust vent on your dryer is restricted or blocked. Hot air will be confined in the dryer and the fuse will trip and stop the electricity from flowing to the gas valve or heating element.

Fixes these symptoms

Not Heating
Won’t Start
See more...

Installation Instructions

Richard from ORMOND BEACH, FL

Dryer would run with no heat

I actually went to mr fix it on u tube. Great instruction on how to take dryer apart. First I unplugged the dryer. I found I could reach the heating system by removing the lint tube in the back of the dryer. I put my I phone with the light on inside the back of the dryer and tested the connections to see if all were working. The thermal fuse was not working. I removed the two wires , red on top and white on the bottom. Then used a small Phillips screwdriver to remove the two mounting screws and removed the fuse. I then used a vacuum to clear any lint from the back of the dryer and inside the dryer. This took me about an hour and a half. I did it this way because I did not want to disassemble the entire dryer to get to the components. I received the fuse in 3 days and tested it. It was fine. I then put it in the dryer screwed it in place, connected the wires. Replaced the lint tube. This took about 10 minutes. Dryer is running great. Read more...

Your Price

$53.68

General Electric Dryer Fuse

★★★★★

4 Reviews

PartSelect Number PS3496852

Manufacturer Part Number WE1M1002

This fuse is a replacement safety component designed to protect electrical circuits from overloads by interrupting power when necessary. It is commonly replaced after a power surge or electrical fault.

Your Price

$40.58

General Electric Dryer Fuse Holder

★★★★★

2 Reviews

PartSelect Number PS11700894

Manufacturer Part Number WE1X21955

Your Price

$39.81

General Electric Dryer Fuse

★★★★★

2 Reviews

PartSelect Number PS10065161

Manufacturer Part Number WE1X21975

The ceramic thermal fuse protects the dryer by cutting power if the unit overheats or experiences an electrical short, preventing potential damage to internal components. When this fuse blows, the dryer may stop running altogether or run without producing heat. A direct replacement designed for select dryer models restores safe operation, but it’s also important to check for underlying issues—such as a clogged vent or faulty heating element—before installing a new fuse. Always disconnect power before servicing.

Fixes these symptoms