General Electric Dryer Wire Plugs and Connectors

Your Price

$40.65

General Electric Dryer Terminal Block And Grounding Strap

★★★★★

3 Reviews

PartSelect Number PS1015628

Manufacturer Part Number WE4M325

This part is connected to the rear bulkhead of the dryer with screws. It provides a way of connecting individual electrical wires and offers protection of the device from electrical surges (voltages and/or currents).

Installation Instructions

Vincent from Washington, PA

Dryer not heating. When moving it away from wall it was sparking badly where the cord hooks up.

Removed case parts to expose internal wiring. Vacuumed up various types of mouse debris and plugged hole they were using. Ordered terminal block to replace the one that melted while sparks were flying. Replaced power cord with one I had in my basement from some other appliance that died a while ago. "Hey honey, ya know those old parts I saved..." :) Now it is heating to capacity and no spark-show! Oh yeah, the part I ordered from Partselect.com was delivered to my door the next day!!!!! Wow! Read more...

Your Price

$15.35

General Electric Dryer Terminal Block

PartSelect Number PS16219761

Manufacturer Part Number WE04X31779

Your Price

$18.53

General Electric Dryer Harness Sensor Assembly

PartSelect Number PS12342983

Manufacturer Part Number WE15X26994

Your Price

$165.54

General Electric Dryer Kit Harness And Timer

PartSelect Number PS11736665

Manufacturer Part Number WE49X23896

Your Price

$59.35

General Electric Dryer Terminal Block Kit

★★★★★

2 Reviews

PartSelect Number PS419369

Manufacturer Part Number 134101400

This kit includes 3 screws and 3 terminals.

Installation Instructions

Arthur from Grand Prairie, TX

Terminal Block Melts when power cord connector is left loose by install crew.

1) Removed Top Dryer Cover (pushed 2 compression clips on front side 1" from top and 2" in from each side) to gain access to terminal block in rear.
2) Removed 2 screws over terminal block cover and 2 screws holding bad terminal block in place. Removed 3 screws holding bad power cord,
3) Removed good terminal connectors from bad terminal block and reinstalled them in the new terminal block.
4) Cut dryer wire from bad terminal block connector and soldered (optional) them to the new terminal block connector. Installed this connector into the new terminal block.
5) Installed new terminal block in dryer with 2 screws.
6) Installed new power cord on new terminal block ensuring contacts were tight and cord had pull guard properly installed. Reinstalled terminal block cover with 2 screws.
7) Reinstalled Dryer Top Cover. Read more...