Kenmore Range Panels
Popular Kenmore Range Panels
Your Price
$109.06
In Stock
Kenmore Range Bottom Panel
PartSelect Number PS977589
Manufacturer Part Number 316400601
This is used as the "floor" of the oven cabinet.
Note: Does not come with rivets or screws. Must be purchased locally.
Installation Instructions
lewis from COLDWATER, MI
Aluminum foil accidentally put on bottom panel ....burnt up, left non removable residue.
After 15 minutes of frustration and back breaking I removed the oven door and had much better access to the panel, from there on it was all down hill.
Read more...
Kenmore Range BOTTM-OVEN
PartSelect Number PS11703263
Manufacturer Part Number W10777210
Installation Instructions
Barbara from MORROW, OH
Foolishly melted a plastic cutting board at a high temperature while baking bread which dripped over two two racks and puddled on the bottom pan.
The repair was very easy, though expensive. Just slid in the racks and installed new bottom with only two screws to remove and replace after setting the bottom pan in place..
Read more...
Kenmore Range Interior Bottom Oven Panel
PartSelect Number PS11740955
Manufacturer Part Number WP3195097
Installation Instructions
Scott from Pine Plains, NY
oven bottom had rusted out
Found that the two screws securing the bottom had rusted away allowing me to just lift the old bottom out. The new one fit in place exactly and really did not need the screws. Done in 2 minutes.
Read more...
Your Price
$148.30
In Stock
Kenmore Range Bottom Panel
PartSelect Number PS1991808
Manufacturer Part Number 316505601
Installation Instructions
Theresa from MOORESVILLE, NC
Replaced bottom panel
Unscrew two very visible screws located in the back of the oven holding in the panel. Remove panel. Install new panel. Replace screws. Could have used new screws but didn’t have any.
Read more...
Your Price
$239.84
In Stock
Kenmore Range Panel
PartSelect Number PS977590
Manufacturer Part Number 316400603
Installation Instructions
ronald from brownsburg, IN
oven bottom had foil stuck on it would not come off
First I removed the two screws that hold the bottom panel I then pulled the panel out and put the new panle in and put the two screws back in
Read more...
Related Kenmore Range Parts
- All Kenmore Range parts
- Kenmore Range Brackets and Flanges
- Kenmore Range Caps and Lids
- Kenmore Range Circuit Boards and Touch Pads
- Kenmore Range Cooktops
- Kenmore Range Deflectors and Chutes
- Kenmore Range Doors
- Kenmore Range Drawers and Glides
- Kenmore Range Drip Bowls
- Kenmore Range Ducts and Vents
- Kenmore Range Elements and Burners
- Kenmore Range Filters
- Kenmore Range Grates
- Kenmore Range Handles
- Kenmore Range Hardware
- Kenmore Range Hinges
- Kenmore Range Hoses and Tubes
- Kenmore Range Igniters
- Kenmore Range Ignitions
- Kenmore Range Insulations
- Kenmore Range Knobs
- Kenmore Range Latches
- Kenmore Range Legs and Feet
- Kenmore Range Lights and Bulbs
- Kenmore Range Motors
- Kenmore Range Racks
- Kenmore Range Seals and Gaskets
- Kenmore Range Sensors
- Kenmore Range Springs and Shock Absorbers
- Kenmore Range Switches
- Kenmore Range Thermostats
- Kenmore Range Trims
- Kenmore Range Valves
- Kenmore Range Wire Plugs and Connectors