Maytag Washer Hinges

Maytag Appliance Parts
Shop By Part Type

Popular Maytag Washer Hinges

Your Price
$140.35
  In Stock
Washing Machine Door Hinge
★★★★★
★★★★★
(23)
PartSelect Number PS11745072
Manufacturer Part Number WP8183202
Fixes these symptoms
  • Leaking
  • Lid or door will not open
  • Lid or door won’t close
  • See more...
Installation Instructions
Theresa from BATESBURG, SC
Not a problem
Unscrewed door screws from washer lifted the door up a little removed door. Unscrewed screws from the glass side and f door remove hinge replaced with new hinge screwed glass door back together. Attached door back to washer screwed screws back in done Read more...
Your Price
$98.29
  In Stock
Hinge
★★★★★
★★★★★
(14)
PartSelect Number PS11750410
Manufacturer Part Number WPW10208415
Fixes these symptoms
  • Door won’t close
  • Lid or door won’t close
  • See more...
Your Price
$4.86
  In Stock
Hinge
★★★★★
★★★★★
(5)
PartSelect Number PS11746532
Manufacturer Part Number WP8563964
This is a replacement lid hinge for your washer. It is approximately 2.5 inches in length and 1.5 inches in width. The lid hinge is what the lid for your washer pivots on. If the lid hinge is damaged, the washer lid may not open or close properly. The lid hinge is screwed into the washer lid. You will need a Phillips-head screwdriver to detach it. There will be a lid hinge on either side of the lid, so be sure to determine if you need to replace both hinges, or only one.
Fixes these symptoms
  • Lid or door will not open
  • Lid or door won’t close
  • See more...
Your Price
$6.99
  In Stock
Washing Machine Lid Hinge Ball
★★★★★
★★★★★
(3)
PartSelect Number PS11738871
Manufacturer Part Number WP211726
This washing machine lid hinge ball is well under an inch in diameter. These hinge balls are sold separately, though two are required per lid. This lid hinge ball is made of plastic and is used for Maytag brand washing machines.
Fixes these symptoms
  • Lid or door will not open
  • Lid or door won’t close
  • Will Not Start
  • See more...
Installation Instructions
David from New Orleans, LA
washing machine lid came off during a move
First, I secured one lid hinge ball in its appropriate position between the lid and the washer. While keeping the first ball in place I placed the other lid hinge ball as close to its intended position as I could get it. Next, I pushed the lid and ball into its position. Read more...
Your Price
$3.96
  In Stock
Short Dispenser Door Retaining Pin
★★★★★
★★★★★
(2)
PartSelect Number PS11757600
Manufacturer Part Number WPY912679
The short dispenser door retaining pin latches your washing machine door to the hinge. If you find that your washing machine will not dispense detergent, or the lid will not latch properly, you may need to replace the short dispenser door retaining pin. This pin is less than one inch in diameter, and is the shorter of the two hinge pins. To find the larger hinge pin, search WP6-912678. This part is cylindrical and is made of metal. The short dispenser door retaining pin is sold individually. This is an OEM part sourced directly from the manufacturer.
Fixes these symptoms
  • Door latch failure
  • Will not dispense detergent
  • See more...
Installation Instructions
richard from austin, MN
Drains but doesn't spin, door lock does not engage.
Door locked light did not come on and did not have 120 VAC across the Wax Motor. Also the Wax Motor did not extend out to make contact with the Door Lock, Spin Enable Switch. General guidance is to replace drive belt and to replace Wax Motor along with the Door Lock, Spin Enable Switches (total of two limit switches). This did not correct the problem. Checked for power and traced loss of power back to the Control Board where resistor R11 was found to be burnt out. Replaced Resistor with new Carbon Film unit, rating of 3.9 K-ohms, 1/4 W and 5%. As a prcaution, replace the Triac (manufactue part number NTE5657), component identified as Q6, rating of 0.8 Amp, 600 VAC. Semiconductor parts must be obtained from somewhere other than Parts Select (unable to find in the small town I live in, I located on the internet at Mouser.com). Unit works great now. Read more...
Your Price
$5.65
  In Stock
Washer Lid Bumper
★★★★★
★★★★★
(3)
PartSelect Number PS11738875
Manufacturer Part Number WP212716
This washing machine lid bumper is just under an inch long. It is all gray in color and is made entirely of rubber.
Fixes these symptoms
Installation Instructions
eunice from prestonsburg, KY
lid closing to far bumpers missing and fuse block cracked
unhooked power plug removed 2 top screws tilted topfront panel back removed cracked fuse holder replaced with new fuse holder put top cover back on installed 2 top screws plugged in power cord done! Read more...
Your Price
$4.86
  In Stock
Lid Hinge Pin - white
★★★★★
★★★★★
(1)
PartSelect Number PS11739380
Manufacturer Part Number WP22002751
This lid hinge pin is almost two inches long. It is all white in color and is made of plastic.
Fixes these symptoms
Installation Instructions
Jon from KIOWA, CO
Broken Lid Cam, Worn Hinges
Simple remove and replace. Plastic cam and hinges simply snap out, replacement parts snap right back in. Needle nose pliers were helpful to remove broken lid cam. With hinges and lid removed, took advantage of great opportunity to clean lid and and top of washer. Read more...
Your Price
$4.86
  In Stock
Lid Bumper
★★★★★
★★★★★
(4)
PartSelect Number PS11747040
Manufacturer Part Number WP9724509
This gray and white washer lid bumper contains a rubber bottom and is sold individually.
Fixes these symptoms
Installation Instructions
Nicola from Centreville, MD
Washer would not run, lid switch broken
Repair was easy. Removed two side panels on the control plate. Removed two phillips screws that hold the control panel to the body of the washer. Disconnected the electic connection to the wires leading to the lid switch. Three sided of the lower cover lift over and removed from the washer frame. Access to the lid switch and wire retainers was easy. Removed two screws holding the remaining parts of the switch and replaced with new. Re-routed the wires through the retainers. Set the sides back on making sure the set all the way back in the frame and fit properly into the plastic strips on the back of the washer. Reconnected wires, screws and end caps. Read more...
Your Price
$18.61
  In Stock
Wire Hinge - Left Side
★★★★★
★★★★★
(1)
PartSelect Number PS11746533
Manufacturer Part Number WP8563965
This lid hinge is a genuine OEM replacement part for your washing machine. This hinge is for the left side of your lid, although it is a good idea to replace btoh hinges at once. The hinge holds up the washing machine lid and can become rusted over time. This repair is rated easy by our customers.
Fixes these symptoms
Installation Instructions
Ed from NEW BERN, NC
Replace hinge and hinge spring assembly.
I mounted the left and right hinge assemblys into the washer (spring assembly) and then mounted the glass top on to the hinge assemblies. Inserted the screws and tightened as required. Read more...
Your Price
$17.75
  In Stock
Wire Hinge - Right Side
★★★★★
★★★★★
(2)
PartSelect Number PS11746675
Manufacturer Part Number WP8572974
Fixes these symptoms

Related Parts