Front Door Ice Wouldn't Work And Air Going Into Freezer
Thanks to the pictorial diagram, I was able to order correct parts. It was just a matter of removal of broken parts and replacing them. Ice maker now working and air is no longer getting into freeze...read more

The ice chute door didn't close all the timed
The door has nylon gear teeth that wore out and needed replaced. The ice chute came off very easy with 6 screws. I used a punch and pliers to remove the hinge pin. Then the door came off and the ne...read more

broke tab on cover bracket
removed old bracket and replaced with new one - two screws and it was done - simple...read more

Bearing chatter and slow running fan motor
assembled ordered parts then replaced defective fan and blade and bracket as a group...read more

Ice maker wouldn't work
Simply took out old part, paying attention to how it comes out. Simply put the seal in, followed by the shaft and then place holder on and screw down with the two screws that were with the old part. A...read more

Kickplate support Clips failed
Replacing the support clips was simple. But since the replacements were the same as the ones that had failed, I modified them by epoxying metal strips on each side of the fingers which had failed. Wit...read more

Rust had corroded Front Plate and Drive Blade
Installation was completed by following the online Parts diagram. Had to completely remove all parts, including the blades in ice crusher, and re-assemble. Glad the online diagram was clear and easy...read more