Maytag Refrigerator Brackets and Flanges

Maytag Appliance Parts
Shop By Part Type

Popular Maytag Refrigerator Brackets and Flanges

Your Price
$17.65
  In Stock
Control Bracket
★★★★★
★★★★★
(103)
PartSelect Number PS11739027
Manufacturer Part Number WP2180226
This is a control bracket for your refrigerator, and may also be known as the dispenser control bracket. The function of this part is to hold the micro switches and the light socket in the freezer dispenser section in place. Its measurements are roughly 9 inches long and 5 inches high, and this model comes in white. The tools you will need in order to do this repair include a Phillips screw driver, a quarter-inch nut-driver, and a pair of needle-nose pliers. If your ice dispenser is not working properly, your bracket could be the problem.
Fixes these symptoms
  • Ice maker not making ice
  • Ice maker won’t dispense ice
  • Not dispensing water
  • See more...
Installation Instructions
BILL from BATESVILLE, MS
Front Door Ice Wouldn't Work And Air Going Into Freezer
Thanks to the pictorial diagram, I was able to order correct parts. It was just a matter of removal of broken parts and replacing them. Ice maker now working and air is no longer getting into freezer which was freezing up ice maker. Thanks for timely delivery, now I am able to use ice dispenser, which I haven't used for long time. Thanks Read more...
Your Price
$7.76
  In Stock
Ice Maker Cover Bracket
★★★★★
★★★★★
(6)
PartSelect Number PS11739245
Manufacturer Part Number WP2198641
This is the replacement ice maker cover bracket for your refrigerator. It is made of white plastic and is approximately 5 inches wide and 2 inches long. The ice maker cover bracket holds and supports the ice maker cover. If the ice maker cover is loose or missing, you may need to replace the bracket. You will also want to replace the bracket if it will not stay in place, or if it is cracked or broken. To replace the cover bracket, simply remove the ice maker cover, then use a ¼ inch nut driver to loosen and remove the bracket. Screw in the new bracket and replace the cover to complete your repair. This is an OEM part that is sold individually.
Fixes these symptoms
Installation Instructions
brian from fresno, CA
broke tab on cover bracket
removed old bracket and replaced with new one - two screws and it was done - simple Read more...
Your Price
$7.76
  In Stock
Bracket
PartSelect Number PS11750601
Manufacturer Part Number WPW10219801
Your Price
$9.11
  In Stock
Holder
★★★★★
★★★★★
(1)
PartSelect Number PS11739144
Manufacturer Part Number WP2188919
Fixes these symptoms
Installation Instructions
Vincent from INDN HBR BCH, FL
Ice Maker Bucket would not rotate arm to dispense ice
This was a very easy repair. First, remove the Ice Bucket off the refrig door. Unfasten the white plastic shaft holder held in place by 2 hex head screws using a nut driver. Remove old shaft and insert the new shaft. Fasten back up with the holder and 2 hex head screws and install the ice bucket and you are ready to dispense ice again. Read more...
Your Price
$42.46
  In Stock
Connector, Door Bracket
PartSelect Number PS11740266
Manufacturer Part Number WP2305242
Your Price
$4.25
  In Stock
Bracket, Dispenser
PartSelect Number PS11740253
Manufacturer Part Number WP2304673
Installation Instructions
Sean from Boise, ID
Water dispenser hose tip broken.
The part to fix this was a $50.00 part.
I purchased this Bracket Dispenser for $6.00 and it fit on My fridge perfectly. I just used the screw hole that was a little higher on the water dispenser. Simply cut off the broken end / or Buy a new Hose (Cost at Lowes about $6.00) guide hose along the bracket and use a socken set to reinstall the screw. Water is not squirting on people any more.
Read more...
Your Price
$7.76
  In Stock
Fan Motor Retainer/Bracket
PartSelect Number PS11738921
Manufacturer Part Number WP2155590
Your Price
$27.02
  In Stock
Gate Support - Right Hand
PartSelect Number PS364082
Manufacturer Part Number 4357293
This gate support is designed to support the gate or fence on your vertical freezer. This part is designed for the right-hand side and differs from the left-hand side gate support. Be sure to note which side of your gate support is damaged before ordering this part. This product is sold individually. It is white in color and is made entirely of plastic. The gate support is approximately 6.5 inches in length and slightly less than an inch in width. This is an OEM part sourced directly from the manufacturer.
Your Price
$49.90
  In Stock
BRACKET- F
★★★★★
★★★★★
(3)
PartSelect Number PS2069868
Manufacturer Part Number 67006325
Your Price
$48.70
  In Stock
Bracket, Ice Maker Mounting
PartSelect Number PS11740231
Manufacturer Part Number WP2303583

Related Parts